Tuxing compressor
- Thread starter xiong_fong
- Start date
Yes I have one . It’s about a month old. Love its speed. Love it’s price ( I paid $360)
I also have a Gx cs4i to compare. If I had to do it again I would only have the Tuxing.
I also have a Gx cs4i to compare. If I had to do it again I would only have the Tuxing.
Upvote 0
I have the version that includes the coolant tank, pump and radiator. I have been using it for over 2 years. Fixed various leaks and use Seco 500 oil. Very pleased with it's performance.
Upvote 0
I have an M042 and it is pushing 2 years old. I don't run any of these *special* oils, just what is recommended by Tuxing, synthetic of some type.
Fills 6.8L in ~45 minutes
Fills 9.0L in ~75 minutes
Runs fairly cool, gets up to 130F or a bit higher when filling a 9L. But I usually dump some ice in the cooling water before I start.
Only issue I've had is the cheap water pump died. I replaced it with a higher flow pump. Needed a reducer from the pump 1/2 outlet to the compressor 1/4 inlet.
Upvote 0
I have one also, it’s fast and fairly quiet. I haven’t had it but a few months and only have 1.6 hours on it but so far I’m pleased with it.
Upvote 0
I bought one about 3 years ago, it worked well for 6 months then I stopped using it until now. Unfortunately is not pumping air anymore so I ventured into changing all the O Rings, seals, check valves, etc. I followed the YouTube Tuxing videos in great detail but it only pumps very little air and will not go above 50bar…. I guess I am doing something wrong, but I cannot figure it out…. :-(
Upvote 0
M012 for me, picked it up a month ago direct from tuxing website. Happy so far, couple friends have the same one, used it for 3.5yrs before it died. They didn't try to fix, just figured it was the cost of doing business and bought another.
Upvote 0
So i picked one of these up. I believe it was the m42 whatever. Packaging looked great, opened her up, hooked up water pump and lines from a bucket. Tried to fill a 2.5lt tank and before it even hit 3000psi it tripped the breaker on the machine. Checked the temps and it was around 80ish 90. Wierd. So reset the breaker and tried again. Only ran for a short time before it tripped the breaker again. It takes a long time to fill a tank. I forgot what the timer said but less than 30 mins of run time. And really struggles after 2700-3000. Not sure whats going on with it. Dead heading the unit just to see if it will reach the 4500psi mark and ut gets there no issues. A bottle on the riffle it does ok. Still slower than my yongheng. Anyone know of what it could be?
Upvote 0
I have only popped that breaker 1 time on my TXEDM042 in over 18 months. That was a hot (95f) day filling 6.8l from empty. Made it to 4200PSI. About 35-40 minutes.
Barring heat related issues:
Either the breaker is bad, your pump end is loading the motor excessively or the motor is bad.
You do have oil in the case, right?
Barring heat related issues:
Either the breaker is bad, your pump end is loading the motor excessively or the motor is bad.
You do have oil in the case, right?
Upvote 0
