Search results for query: *

Thanks! That O-ring is supposed to be 7.5x1.5, measuring something squishy with calipers is damn near impossible so you were really close. Another O-ring altogether ended up being the culprit. It's the little 4x1.5 one hidden deep in the reg body, also not included on the diagram (ffs FX, how...

Hey gang, I found the O-ring that's most likely the root cause of a slow leak from the front reg I've been dealing with for weeks now. Problem is, it doesn't show up on FX's parts diagrams. Does anyone know which O-ring this is?

The silicone has long since been removed but the issue is still there. Also, the issue started before I ever touched it with silicone grease, which is why I applied it in the first place.

Anyone else have the issue of air bottles getting really tight to screw on/off? To the point where I start to worry about the amount of torque I'm putting on the bottle itself. Mind, I'm still screwing the on with bare hands but especially if you can't get a good grip, for example when screwing...

Just installed a 300 bar Wika gauge on my M3, seems to be reading about 15-25 bar low. Previous gauge was reading 300 just fine but would be reading about 20-30 bar high by the time it got to my 1st reg pressure (120 bar). What could be causing this? And what are the chances of my Hill...

That's pretty strange... I can push my .22 cal M3 to 155-ish bar on the 2nd reg before the velocity levels off with the standard hammer/spring combo. 120 Bar seems really low.

Fully decked out Impact M3 in .22; 800mm barrel, slug kit, the works. Five meters, because that's all the space I have in my student apt.😇

Just ordered a .22 cal, think I might be the only one with a BC magazine in the Netherlands...

Could try that, yes. Thanks Tom! It was so cool seeing you and Mathias bring them out to RMAC, and very good to hear you're still happy with 'em.

Thanks!

Good suggestion! I think with thin covers like this it would start warping but I can give it a try and see what happens.

Thanks for the kind words, really appreciate it.

Finally, .22 mag is production ready. I added one final design tweak, replacing the ring and flange bolt design with a single plain steel wide flange DIN 921 extra wide flange bolt. These are a lot more consistent dimension-wise than the aforementioned rings, so even tighter tolerances could be...

Aimpoint comp m4 on an Impact M3. Swedish combo! 🇸🇪🦌🌲

That's exactly what it was! Just that little grub screw. Gun works a-ok again, thankfully it was just the one blown O-ring. Thanks for the feedback!

Hey good people, I did a bit of an oopsie during a hammer swap on my M3 and may or may not have attempted on unscrew the plenum with 100 bar inside. The damage seems to be just an O-ring on the plastic part towards the receiver, inside of the plenum (which has now been replaced) but I also...

Just got the first batch back from anodizing an oh boy :)

Nawwwww, congratulations!

Oh hell yes man, we've been collectively waiting for this one for months. Going to be a great excuse to finally deep-dive into tuning my M3. Thanks Steve!

Adjust the pin probe back a little bit. More of an issue with shorter slugs but I’ve been developing a magazine for the M3 for the past 5 months and was at a loss with this issue for quite some time. Turns out the thin part of the pin probe pushes the slug clear of the cassette before the...