Search results for query: *

yes, I'm still doing these. there is a notched out section at the rear trigger area that prevents the rail from sliding around. if I recall you will need to work in a notch that is there to clear the blade of the trigger guard.

I realize you can't make holes smaller, but you can make smaller holes bigger. We are only talking about making a hole .0005 larger. So a .247 diameter bushing could be turned to a .2475 diameter by lapping

NOE has sizing dies. for 25 airgun to get down to .248. you then need to go under this one to get the .247 and smaller if needed. you could take the smaller sizes and lap them out to the bigger half steps you're after. example: take a .248 sizer lap it to .2485. Be the faster and probalby the...

same here.

i cast pure lead exclusively

the the .25 cal rf slug mold is killer as well. i have video of shooting out to 208 yards with them

pretty sure the mp's are 35.6 gr soild nose.

im using a FX impact mk2. 700mm setup. they are accurate and work well for me. I lube and size them down to a .218.

got my impact mk2 720 power plenum and power block back today. shot a few shots as received from FX. plenum fills with every shot. shot about 1/2 a mag in 22 cal and it only used 6 bar of air. not sure what current fps is, as it was late when I got home. need to run the numbers and check over...

got word from fx. my upgrades to 72 cc plenum and power block are complete. my gun is undergoing leak check and I should be hearing from customer service to square up my bill and get the gun shipped back to me. getting excited. talked to the tech and he says it's a hammer so far.

I can make this available for those who can 3d print that are outside the usa. Shipping would be expensive for overseas orders. I can post it on my 3d cults page.

im a caster. full fill in the pellet skirts is a bad idea. it kills accuracy. I have molds that have changeable pins for different weight pellets from the same mold. no one yet has been able to utilize full filled pellet skirts and kept accuracy intact. new molds from NOE no longer have pins to...

fx usa currently has my impact and the order has been put in to get the work done. so a few weeks and i should have it back now.

hmm. this is concerning to read. My mk2 is headed to fx for warrantee repair on the pin block that aligns the barrel to transfer port. I figure if I got to send it in and be without it for a few weeks, FX might as well upgrade my MK2 to the 720 plenum and new power block. I mainly shoot...

are we ever done tinkering???

No problem. here you go folks. right side mirrored in this zip.

Nice add on this version fe7565. you beat me to it. still working on the cant meter. getting alot of bad data and erratic readings. tired a few different options. I do have the 3 dots mapped out that can be put in place of the R%. that was a fun venture. could be a user option to comment out in...

so playing around with my m5 stack and the gyro to see if we can get a cant meter setup into the display. From what i can find it appears that gyro "z" is the one needed to show us left right tilt if unit is attached to the pic rail and the display facing us. still working to dial in and be...

using PC,, i tried the discord link but it says the invite has expired

got my m5stickc plus. uploaded and have been able to connect to chrony using version 4 and 6. but neither is registering shots. if i hook through phone app the chrony is seeing the shots taken. i compiled and uploaded to stick using m5stick-c in Arduino. I see no board choice for plus...