Search results for query: *

I have the same problem on my Airacuda Max. I tried contacting the company 2 times and still no resonce. Does anyone know where I can find instructions on how to fix it myself?

So I got a reply from Hill Support to try and fix my issue of blowing fuses when started under pressure. Hi Bob, The issue you describe is most likely related to some aspect of stage 3 not functioning correctly. If you would feel comfortable doing so, below are instructions on how to access...

The next time I have issues or maintenance I will try to document it with pics

As it turned out I found a o-ring for my stage 3 I had as a spare. Put it in and now compressor is running better than it has in a long while.

When I Started Airgunning I looked at Yong heng Compressors. The impression I got was they were Chinese made and were low quality and HIGH maintenance, so I bit the bullet and bought a Hill EC-3000. As time went on I discovered that the Hill was ONLY for filling guns not tanks. I spent so must $...

you can also order a 50hr rebuild kit from pyramydair

took Compressor apart last night and found that my Stage 3 Piston seal was shridded and there was a lot of rust on the piston. Not sure how that happen. I orderded another set from Hill and when They arrive i will see if that fixes it.

Just did a 50hour maintance on my ec-3000... after about 1hr of fill later I now have the same problem of stalling under pressure restart. so much so as it blew the fuse on the power suppy. I ordered new fuses and I will try to disassemby the compressor over the next few days and inspect for issues.

last time I contacted Hill they sent me parts Free or charge.

Today I received my new Air Venturi 74 CU FT Air Tank I started filling it with a compressor. when is got to about 298 bar it vented a little bit of air as if I had blown a burst disk. What was wierd is after it vented, it went back to filling with no leaks..I know when a burst disk blows thats...

I've had one now for 3 years as well..have had a few issues with it but Hill Support is really good. Just did the 50hr maintance on it over weekend. takes about 1.5 hrs to fill my 45min scba tank from 3000psi to 4400psi

Can someone tell me how to fix the Butt Stock on a Gunnar. Very loose fitting. have tried stuffing paper to tighten it up but doesnt work. Anyone fix thiers?

Hi Guys, I just have a quick question, I own a lot of $300-$800 airguns from Avenger, JTS , Benjamin,etc mostly .22 and a few .25 I have always looked for bargin guns cause I never could shell out a lot of $ on a gun. What I found is almost all the bargin guns function about the same. some good...

I will be shipping the gun back..What carrier do most people use? USPS is cheaper but not sure they will take an airgun.

If I cock gun it slows down leak but doesn't stop it..It will lose all air within an hour

Hi Guys, I have a benjamin kratos for about 6 months now and today it started leaking air out the barrel. 1st I took the barrel off and replaced the o-rings. That did not stop the leak. I then called Crosman support and They were not much help told me I would have to send in gun. Anyone had this...

I think There is a procedure in the Manual which address this issue maybe this vid will help solve it

I bought them off of Amazon...

I added a check value with a gauge inline with the scba tank so I can turn on the tank before the compressor comes up to pressure and when the pressure equals the tank the valve opens. When done I bleed the compressor 1st then bleed the tank at the check valve to minimize moisture

MODERATOR EDIT:. Political based content removed.