Search results for query: *

I have no thoughts on that gun, but I think you'll get it sorted out eventually. I did however enjoy your writing skills. You may have a calling there. Good luck and hang in there with it.

Every time we eat out, buy groceries, fill up the truck, dam near anything that involves forking over cash these days. I think I'd feel less sick, forking it over for a new gun. At least it would be fun...

I had a 25cal Royale that had the smaller stem and valve. In a quest for more power, I installed the larger seat and stem plus some internal opening up. What a beast it became. Stick with the larger valve assembly. The smaller might be a 12ftlb version.

I remember a couple of years ago when FX would watch the forum and address concerns just like this. Too bad they've lost this contact with the customers. And you'd think to that Utah Airguns would be monitoring the forum as well and giving a helping hand when needed. You know, being proactive.

I changed the AA T-bar on one of my AA for the convivence to fill like my other guns.... but I never had the T-bar thingy pop off and scare the crap out of me like I've had a probe and QC do. I wouldn't go back though.

It adds additional stiffness at the same time. Just like if you removed one from #1 regulator stack (less tension), lower max pressure.

If you're going to order those you might as well get the others needed if you pull the regulator out for a rebuild. Very cheap and you'll have a lifetime supply. There's the one that's just inside the regulator body, that seals the piston shaft to the ID of the regulator body, 10X4 I think. It...

Thanks for sharing..

You can also find a wood block or something similar to wedge between the crank and the housing as a backup when you want to loosen or tighten the bolt again.

Isn't that about like a M1 Garand and I thought that was heavy?

Back a couple of years ago they might have. Sure was nice to know that they occasionally did until numb nuts fudged it up.

I received my order yesterday. The two-pack turned out to be a one-pack with one battery loose in the package, the other nowhere to be found. No openings on the package. Sent them a note so hopefully they will make it right.

Gerry, if it's the cost of the pellets, have you considered casting them? Since I've started casting 30 cal NOE pellets, I bet I haven't open, one or two tins of my 30cal stash of JSB and Hatsan Supremes in the last year or so. They shoot really well out of my FX Crown. I call them "free"...

I never thought about checking Amazon. I just ordered a couple from AliExpress and they were higher than Amazon's 5 pack. Amazon's price is cheaper than buying a couple of batteries.

Some of the Tuxing parts are interchangeable. Just need to look them over closely and see if they are a correct match. AliExpress also has some parts. Here's a thread from a while back that may be of interest to you...

Pyramid Air has some of the parts. You probably need to determine how much damage was done and what parts might need to be replaced.

I own a Shoebox F10. I, like probably like 80% of the membership recognize, knowing the current production of the "Shoebox" isn't. Now when I hear someone talking about a newer, small, cheaper, priced compressor I've come to take it as the common reference as being a shoe box compressor, not...

This listing has been renewed

That's a nice one for sure. I'd like to find one along that line.

Did you try another dead headed test after the tank attempt and fail? Hopefully it's something to do with the fill valve on the tank.