Search results for query: *

True, but it takes time to set up a production line. At the same time (most) things will have gone up in price, (since a lot of resources/parts cannot be just dug up locally and thus have to be imported anyway) so people demand higher wages to compensate the higher cost of living, and inflation...

No experience with those, I’ll check them out. I see at Pyramid they are the equivalent of $11.25 per 500 (buy4pay3deal) so not as cheap as the CPHPs, but still a lot better than the other brands… If it is true that the CPHPs production is shifted to Spain (where Gamo originates from) they...

Anybody know why the CPHP .22s are (due) out of stock every where? (well Amazon still has them, but none of the ususal suspects...)

Nope, I exchanged it for another. The new one is working fine.

Nice find! Too bad it looks so ’clumsy’. I’d have preferred an FX Maverick type sidelever… (but maybe when anodised in black it looks less obrusive)

Pairing the DNT Zulus/Thermnight with a Notos is a bit of a PITA for 2 (or 3 if using aftermarket magazines) reasons: First: The small (halfcut for finger clearance around the sidelever) picarail behind the magazine cutout is too short to mount a digital scope mount, as it is much longer than a...

Yes, thank you, Black Betty is up and running again!

Ok, so I just gave it another try, and it finally gave way! Now let’s find a new fitting O ring!

Does the trigger (pull weight) vary by every couple of shots? If so, this is most likely due to a rotating hammerweight (which is held by the sear). This greatly affects accuracy in a (very!) detrimental way. Unfortunately I have no solution what can be done to fix (i.e. Stop) the rotation of...

Thanks, hopefully the Notos guru himself (@Firewalker) can chime in here with some advise…

Hi guys, My Notos with Huben Cricket/Dream(?) valve managed to expell an O ring at the base of the bottle connector part. I’ve tried to grab the round part with pliers and a leather strip, but the pliers keep slipping. I then took off the bottle shutoff valve and the fill probe to see if that...

I don’t know about the “time warn pin hole camera”, but the 6mm hole concept works exactly like your old analog SLR camera’s diaphragm; if you make the (lens)opening smaller, the depth of field increases. Same as when looking through a diopter or pinhole. This comes at a cost though, as less...

Yes they can be easily found on Aliexpress

Yes it does. (as it holds a maximum of 26 profiles, it would be quite a lengthy enterprise if you’d have to redo all of them after a battery change…)

Yes look (I think) under the toolbox tab. You should get a popup like so: In the white box you can fill in the ranges you want displayed on the tape. Mind you manually need to add a space between the numbers you fill in there

Get a small piece of leather, (not the soft nappa, but the sturdier type used for straps etc.) put it halfway around the gauge and use an adjustable wrench. Then Bob's your uncle!

Haha, it is a rubber gasket normally used to connect pvc piping with different diameters. The focusknob is very stiff, so it gives some extra grip and leverage. The “crossthread” was done with a soldering iron. Nowadays I would just design something to print on my 3D printer, but this is a relic...

https://turretlabels.com/ or you can do it with Chairgun:

You’re welcome! No difference noticed with or without the airstripper…

under the shroud: I did. Well, sort of. I experimented a lot with various setups (as can be seen in the pics), on top a (home made) carbine shroud, in the middle the OEM Plus shroud, and bottom a (homemade) HW (Weihrauch) setup. The most silent of the three turned out to be the one with a...