Search results for query: *

I was right next to that table😆 It was a good show..definitely enjoyed it and hope to go back next year.

The filters are about here.. should be within the next couple weeks. I'll have an affiliate link posted as soon as available. As far as new products, I'm not sure if the mention was referring to GX or some other brand or item. There are a few things coming up with GX, but nothing that's going...

I'll be there. Have 3 tables. Compressors to sell and a few antiques to display. Still trying to decide what other things might be interesting to sell or display

You don't need to change all the water out, but remove at least half to 3/4 of what's in that water tank and replace with water wetter. Just remember, if you're in a climate where the compressor could freeze, be sure to have enough anti-freeze in it instead.

Just be sure to use something like water wetter or antifreeze mixed with it. Straight distilled water will cause corrosion over time.

It's the part that is attached to the top of the cylinder head with a Phillips screw. Follow the wire to where it's going to either be plugged into a harness or directly into the board. Just unplug it.

They will be on ebay, or just call/email the contact info on the website. We will be putting some kits together tomorrow. Everything on ebay is less for a direct sale... plus shipping rates are usually cheaper with direct sales.

I have a few put together that I'll be taking to the Indiana show. They are for replacing the low pressure seal. They will not be complete O-ring kits like GX sells. But you will get red and clear grease, that tool for removing the wrist pin and piston, along with wrenchs and other tools...

Gx accessories page. They have the full kit https://gxpumpofficial.com/?ref=BBSGLLC

It can easily drop temps that much. Glad you tried it!!

The first shipment will be here next month

The check valve on top could also need cleaning out and be sure the spring is in correctly. Loose wires to the board can do it as well

Correct. Also the temps stay about the same in either position.

Glad it worked out!

You can tell the whole radiator is being used in this position by using a laser thermometer on the opposite side. Or just touch it... There is a divider between the ports inside the tanks. They are just off the shelf universal radiators used in other applications, such a computers. The...

Correct, that is why I prefer to run it "backwards" and have the hot come in at the bottom. There is a divider in the radiator, but they sometimes are not perfect, so hot coming in the bottom, I just trust more and results in several compressors so far show it works. To force it as in a car...

It's easy Drain water Unhook the two water lines Unplug the fan 4 screws in front hold the fan radiator assembly...remove them Remove the drain line Slide radiator fan assembly out Reinstall as in the photo Replace screws and wire for the fan Cut water lines to fit Reinstall drain line And...

The water still exits the water pump to the cylinder head, from the head to the bottom of the radiator and out the top of the radiator to the reservoir. You can switch the hoses around, but I would rather see the water forced up through the radiator and out to the reservoir. This is not like a...

The picture is showing it rotated, from the factory both inlet and outlet are at the bottom.

Bleeding the air pocket out of the cs4 models is simple and easy to do, and it'll result in lower temps, many times significantly. However with about 15 to 20 minutes of work, you can potentially drop up to another 10 degrees. It involves rotating the CS4 radiator and fan. Nice thing, the...