Search results for query: *

Riton X3 Conquer 3-15x44 IR. Side focus down to <15yds, 30mm tube. SFP, illuminated MOA reticle w/holdover stadia. Reticle is slightly dimmer on the left side. This was noted in a review that I read. Called Riton & they will correct it. I didnt use the illumination, so never sent it in...

Accushot 3-12x44, 30mm tube, SFP, mil-dot. Side focus down to 10yds. Includes sun shade. Mild ring marks & short scratch on objective bell. $77 shipped in USA.

Center Point 3-9x40 AO. SFP mil-dot reticle. Focus down to 10yds. Made in Philippines. Perfect condition. $68 shipped in USA

Pride/Fowler Rapid Reticle 3-9x32, 1" tube. This is a .22LR dedicated, FFP, fine crosshair reticle w/holdover stadia out to 200yds, in 10yd increments. Parallax from 50yds-infinity. It's a Japanese Sightron S1 made for Pride/Fowler and is in perfect condition. $175 shipped in USA.

*SOLD* FX V1 chrono w/velcro straps & screws. Very clean & works perfectly. Includes 3 AAA lithium batteries. $125, shipped in USA.

Relisted seperately.

This is a Webley & Scott Hurricane scope mount in excellent condition. Sold the pistol long ago. $32, shipped in USA.

3D printed .22 single shot tray for AEA Varmint, HP SS, etc. $13, shipped in USA.

After about 1000 rnds, my HP SS + would stop firing. During the firing cycle, at least 1 pellet per magazine would follow the bolt probe rearward, getting stuck in the hammer/trigger area. I finally discovered that a worn breech O-ring was to blame. After replacing it, flawless cycling resumed.

Selling a .22 HP Varmint Custom with a Utah Airguns installed regulator (set to 160bar). I've shot ¾" groups @50yds with JSB & FX 15.89gr pellets. Holds air indefinitely. The bolt & hammer are polished to cock smoothly & much easier. The trigger breaks @ 2lbs 12oz. The factory mags are long gone...

Selling my .22 HW100KT. It's in dang near perfect shape. No modifications of any kind. Walnut thumbhole stock w/no dents that I can find. All metal is perfect. No leaks. Comes with two factory 14rnd mags, 2 piece factory fill probe, smaller fill probe from Huma, tools to disassemble the air...

This was installed on a .22 AEA HP SS Plus simi-auto. Once the gun's springs were dialed in with regulated AP set to 150bar, the gun ran well and shot count increased too. I've included a pic of the gun w/reg & a 4 section Huma30 installed. I sold the gun in its original form so this is...

My Jet 2's receiver has developed a crack underneath the forward rear sight. Upon firing, air leaks out . Has anyone else seen this problem?

Does anyone know if one of Carm's magazines will function in a Hatsan Jet? I have a 14 rnd .177 Sortie mag for more shots, but it's still tedious to load.

Found a very nice Pardini K58!