Search results for query: *

Anyone know where to buy a fiber optic front sight for a HW75 or 45? I found a rear sight but no front yet. Thanks

Looking for a used HW45

Very clean Hawke Sidewinder 30 SF 6-24X56 SF : SR Pro IR No ring marks or dings Scope tracks perfectly. Lighted reticle works great(red/green) Clean bill of health from Hawke 6 months ago.(I sent it in just to have it checked over) $285 plus shipping Price is firm and shipping is extra. Paypal...

The hour meter on my compressor reads in tenths. Right now it reads 13.8 How do I convert this reading to hours and minutes?

Looking for a nice R9 or possibly a HW50 Thanks

I'd like to remove the barrel shroud on my Taipan Veteran long .22 and use a Tanto moderator directly on the end of the barrel. Will this work with regards to fitment? Thanks

Would like to buy your 2021 or newer .25 K1. Thanks, Norris

I have a 2023 Pathfinder XR that I’d like to trade for a 2021 or newer Huben K1 .25 cal. My Pathfinder is in excellent condition with two BRK magazines and a case. PM me for pictures. Thanks

Here's a 10 month old TX200 Walnut Lefty Hunter Carbine. Zero issues. Shoots great. Not much else to say. I bought it new and because of my age(health) I cannot cock it anymore and I don't have any kids to pass it on to. It has had a Vortek piston seal installed to replace the original seal...

What are these “flakes” of aluminum (?) on the receiver beside the loading port of my Pathfinder? I also have them on my Cayden…..none on the rest of my guns.

I bought a used Pathfinder 5-6 weeks ago. It's a great gun shoots 18gr AAs fairly accurately. I carry it in my truck most of the time. Yesterday I had a chance to run it over a chronograph for the first time. I expected velocity of the 18gr AAs to be something above 800fps. Velocity is actually...

I just bought a used BRK Pathfinder that the previous owner adjusted(lowered) the regulator pressure and hammer spring setting as he was trying to get the shot count up. I can only get just over 22fpe out of it and would like to go back to the factory energy levels of approximately 27fpe. I’m...

This is a picture of my upper breech seal after 5-600 shots since I replaced it for the same reason. Thought I'd ask here to see if anyone might have a fix. These are supposed to be "factory type" breech seals. Thanks

I have an almost new TX200HC. I ordered and received(in 5 days) a TinBum Short Stoke tune kit from TinBum in England. I'm getting ready to install it and I'm going to use Krytox instead of TinBum's moly lube that came with the kit. I have cleaned all of the old lube out of the gun completely...

What is the reason for the grooves in the receiver bolt on a TX200. I've seen 3 on most, 2 on some and my new TX200HC has no grooves. Thanks

I have a R11 that I bought new in 2005. I purchased it to use it as a "practice gun" as I was into powder burning bench rest competition at the time. Turns out it wasn't good for my intended purpose, so it has spend almost 20 years in my gun safe. Maybe has had 1 tin of JSB 8.44s shot through...

Did a search but still have this question.......Is the quality of the Air Arms TX200 that much better than the HWs and Rs to be priced so much higher? I have a chance to pick up a AA TX200 Hunters Carbine but it's several hundred higher than the German guns. I already own a R7 and R11 so I know...