Search results for query: *

Don’t notice anything damaged, also don’t really know what I’m looking for. It is dirty because I took it out about twenty times now trying to figure out what is wrong.

I have attempted not seating the regulator all the way in the gun, reg set to max pressure and at lowest pressure the same issue. I also did the same with first stage regulator with the same issue.

No leaks. I literally fill the gun and zero reads on the regulator. Not even a tiny bit of air comes out when I shoot. It is like the stage two regulator is blocking something. I literally just took the stage two regulator out and cleaned it and the gun is getting zero air. I’m starting to think...

The Mora is easily more accurate than my impact and Panthera. The issue at first was the speed would drop and after filling the speed stayed the same and continued to drop. I took the regulator out and cleaned it. The big issue now is the gun will not pressurize and the gun reads zero on the...

3-4 bar drop till it is off the reg as well. If it sits over night, the pressure goes back to set pressure. I was thinking of putting softer spring to help get back to pressure

I have a sekhmet digital gauge for the reg and put a new gauge for bottle pressure. I assume the extra high pressure Belleville washers make it hard for the regulator to style in when getting close to set pressure. With a fresh fill, the gun will get about 8 shots on set pressure then has a hard...

Will the Fx impact regulator fit in the Panthera? I installed the extra high pressure Huma regulator and the recharge is very fast. The issue is the regulator drops in pressure over a period of time after shots and can’t hold the set pressure. For example I set the reg to 155bar and after a...

I want to see if I can start getting into swaging slugs without spending $3000 for a Corbin press set or presslug. I need ideas please.

It’s weird that two separate regulators are doing the same thing. I’ll try that. What does the brass screw do that is above the front brass plug for a front bottle adapter?

This rifle takes a couple minutes to get back to the set pressure or even get close to the set pressure. I bought a Huma reg and it helped a little bit. Is there a screw too tight somewhere restricting air to the regulator I can check?

I have had many me for a couple of months and about $400 in ammo on it and still can’t get it to tune. The original valve pin bent hitting front hand guard block poor design. Second the regulator took over ten minutes to get to set pressure. Get a impact M3

I have a Huma pin probe for my Panthera .22 600mm barrel. It jumped velocity about 10-20 fps dependent on slug. The consistency in the velocity doesn’t seem to be as good as stock though. The weird thing the groups are a bit better even when the consistency was not as good.

It did the same thing with stock and new regulator.

I had a question about the Panther. Right now I’m getting closer to getting this rifle tuned but noticed even with dual bottles at best it gets 3 mags. My Impact Mk2 with 58cc plenum with 580cc bottle at 300 bar gets 3+ mags. Is there a way to reduce the amount of plenum size safely to reduce...

I actually set the reg from 140 to 150 and wow it shot hole on hole for about ten shots at around 993fps. The bottle was at 250 bar fill. Once the bottle went to 200bar, the gun got really in-accurate again. Why does it do this even when the set pressure is lower then bottle pressure?

If you sell your set of 4 hammers on eBay I think I bought your set of hammers recently. Haha. I just ordered a couple different brands of slugs with different sizes and will hope this helps.

I’ll try and bump it up to 150 and see how it goes

Can someone give me a tune for a .22 cal 600mm barrel with a heavier hammer like 14.8g brass hammer to try out