Search results for query: *

a gunsop and co owned a couple others. For many years I owned a couple others. Did years of gunsmith ing also, built lots of custom guns. I also live just outside of town on 8 acres where, back in the day, I could shoot anything. But times change, the shops are gone, and some of the closest...

I found my impact mk2 uses same orings as fx factory reg and those are listed in the parts diagrams.

Reg 100-115 b Hammer ~15 Xfer 177/22 This should be close to 890 fps for 18.1 gr. It's at least a place to start. Those are my settings.

This is one reason I like the new one piece barrel adapters.

good luck, but don't woory about dry firing a pcp. The only time you "might' hurt it is if it had little or no air in it. As long as it has air, then it's fine. Some guns don't have a last shot indicator or warning, and get dry fired almost every mag.

I still can't figure the gauge out. I cannot get it into the battery charge state at all. I cannot tell if it's charging at all except it's not going dead, so it must be charging It stays on for like 5 minutes when I touch the screen. Does any of this sound normal?

Me personally 1) a good 12 fpe.177 2) RTI Prophet 3) 2nd Crown

This listing has been renewed

Hydro testing is not destructive testing. Destructive would be pressurizing the cyl until it failed. Understanding fatigue and resiliance is a complicated science. The short answer is that even hydro testing doest come close to the permanent damage pressure. It does contribute to cycles...

I really can't imagine FX putting them in that tight or with loctite. It could get inside the reg and foul up the machinery. Did you buy it new? Or is it possible a previous owner did this? I would use a new Allen wrench and a short cheater and try to get it to break free. CCW is correct. As a...

This listing has been renewed

The one thing I do is to check the female fittings for the number of ball bearings in the collar. The more the better and at least five. The cheapie have four, the really good ones have six. I have notice the GK fittings can be tight, which is good, but too tight can be a pain.

I've searched and can't find any info on my issue. I have a 25mm gen 2 gauge, and it has worked well. I sent the gun off to be serviced and it is still reading pressure well, but the battery symbol shows low charge, and I can't get it to go into battery level mode. Also, it looks like it's not...

This listing has been renewed

Get a piece of 1/4 polyethelene tubing. Works like charm and costs $1.

Yes, you make a great point, but it's just something that stuck out to me in chrono'ing various pellets. None of my other rifles have this problem and at least a few of them have Huma regs, so it made me wonder. I can say, the Crown is startlingly accurate. I've shot some of the best groups...

I agree, I had two of them, and they were scary accurate. Umarex may not be a top name in the best airguns, but they have got the barrel thing down pat.

Having a lot of fun tuning my Crown for multiple calibers and noticed an anomoly The first shot is always 5-10 fps high, then the gun settles into its normal, less than 10 es for whatever string length I decide to shoot. I just glanced at my reg gauge each time and it's always on 100 bar right...

This is one of the best scopes Athlon makes. As new. Sells for $529 new. $300 shipped in con US

This listing has been renewed