Search results for query: *

Hi everyone, does anyone know if the holes on the side of the picatinny rail works with m-lok? fx wildcat mklll thanks Frank

so loosen it more? if you look at the chard you can see the numbers for minimum, 1,2.. If I shoot it at number 2 it is the same.. Did that today.. And I would like to hit from 850 to 910 in velocity.. You think that can be possible? If I shoot it next to my ear, I can hear a little whistle in...

But cant really use the statistic, because some of the shots have been fired when the rifle had settle in velocity, and some of the shots have been fired when just filled up.. It is like there is to much power for those first 5 shots and then the rifle settle.. How to fix that?? regulator...

Hi.. From Denmark :-) I have a problem with my dreamline... I set the reg pressure to 135 The power wheel is about18 mm FIlling the rifle to 220 bar and then go shooting the first shots will be a little spread on 25 meters.. mayby 1 cm high of aiming point.. then they will start crawling...

Here is the numbers.. it is the section in the bottom that is from today... The numbers in the bottom is the spread, and the next is the average speed.

Did a little cleaning of the barrel.. Need to do it better, but better than nothing.. Shot again at 45 meters... top is hammerwheel on minimum 1 2 3 4 5 Max nr 4 is witin 1 inch I shot from left to right, so the picture is turned half a turn

Just shooting this morning.. tried group testing 45 meters.. hammer tension from min,1,2,3,4,5 max.. Best group was within1,5x1,5 inch Shot it in at 25 meters. again, could shoot it in so hole in hole.. Then going inside fill it up to 220 bar... reg pressure is 125 bar. Going out...

I havent shot a lot with it... But before I made any changes it seem to shoot more consistent. ( I bought it second hand) But the changes I made is pretty much the same as it was when I got it.. But again I havent shot a lot with it before i made the changes.. mayby it whas a bit warmer those...

thanks, I will try lower the velocity.. Did clean the barrel. but not with any oil.. The JSB are 15 grains..

Hi hope you can help me here. I´m new to the pcp world and bought a dreamline 3 weeks ago. I tried tune the rifle by setting the hammer to max and reg pressure to130 bar. then shooting over chrono and adjusting the hammerwheel down. I had to loosen the hammer some and found shooting jsb 15,89...

Hi everyone. I hope you can help me. I'm about to buy a PCP rifle and have two options. 1. second hand FX dreamline, with stx line, fx power plenum, and Donny fl sumo moderator. cal. 22. shoots around 870 ft/s and 50 shots before it needs refill. comes with 1 mag, and I have 2 from my earlier...