Search results for query: *

Take the reg out take all of the washers out clean each one put a light coat of silicone oil could have a tiny spec of trash make sure you do not mix the washers they are different thickness and different direction pay attention.

I have a TJ3 that I just bought a month later the large gauge blew out the oil plug no clue why I called them and that evening they had a new one on the way no complaints about there service

I personally don't like the fat boy it such a big diameter SUMO is not small but its quiet the donny fl's by FX dont have the internal guts that the real donny's have and there not as quiet mine has baffels a stainless screen and some felt. I have 4 of them and a 0db which isnt bad but its not...

Longer barrel is not gonna make it quiet

If you break the sound barrior it will be loud but with a Donny Sumo what the pellet hits is 5 times as loud as the report

I shoot with a SUMO at our club the person sitting behind me cannot here the shot all they here is the steel being hit its that quiet

donny FL SUMO

If doesnt hold air you have a bad o ring somewhere

I have polished a few FX liners/barrel it takes a little time, but it is not hard doing it will give you better groups and help with led fouling, but I agree it should not have to been done that's where FX screwed up, they should have designed their guns with LW barrels, and I think they would...

I have a FX Crown and mine takes about 4 shots the 5th shot is dead on I don't know but I would think it's the reg it's the only thing with a moving part as far as pressure the hammer will hit the same each time it is a mechanical device FX has the amp regulator. Someone that has installed the...

Yes I agree my crown 500mm barrel shoots 10.3 pellets at 930 reg is at 100 max setting on wheel but I can re adjust the hammer and push it to over 1000 but the pellet flight is unstable which puts it well above the 20FPE but the sweet spot is at 19.4FPE that will make a 3/8" group at 35 yards...

Joe B. gauge works as it should tank gauge and fill gauge comes with whip and foster quick connect. $140 shipped conus. pay pal its the 7/8" thread. Cell # 985-817-1829

This listing has been renewed

This listing has been renewed

This listing has been renewed

This listing has been renewed

Simple answer yes

That might work but I put the new guts in the old cylinder and it’s sealed I am leaving it alone

Nope it was leaking where the main section in question was screwed into the valve, I knew it was going to leak but I did what they said to do. I took it back apart and replaced the new guts into the old whatever it's called with the Oring.