Search results for query: *

The CS4I also has the internal converter.

Here's a better picture

Here is a link to the page where the 3D printer file is. The revised plan works better than the original. My buddy made two for me and I just got some 90 degrees rail adapters from Amazon to attach to the rifle. I also drilled holes through them and used Allen screws from the hardware store to...

Thank you all for the replies. At this point I will fill to 230 and see how it does. And I will also try and get new linkage.

I do the same on the fill.

Thanks I will do that and see if I can get new linkage. At this point it's out of warranty so I'll see if I can order it.

Thx for the reply. So the tank gauge has a green section and then red. The manual says you can fill to the max since the regulator takes care of the shot to shot pressures. Yes used. I purchased it from the original owner that left it how Air Guns of Arizona set it up for him. He said he...

I didn't get any replies but I did find a 3d printed mag holder that seems to work great,

I have a Brocock commander XR .22. One of two issues I'm having is the roll pin that connects the charging handle to the linkage keeps falling out. It is the factory roll pin so the size should be correct. The guy I bought it from said it was even doing it when it was new, Just wondering if...

This is my first post on here. I'm looking for a mag Holder to mount on my Brocock Commander XR in .22. Preferably for 2 mags. I've been looking for a few days and can't seem to find one. All I find is mag cases and that isn't what I need. Any help on finding one would be much appreciated.