105 Yards with my ACZ Dreamline .25

Finally stretched my .25 dreamline out to 105 best group with 25mph winds. I was NOT pleased with my fps at only 815/820, reg set at 125 , shooting 25.4 gr jsb but it was like 20-25 degrees out. I feel the cold slowed it down quite a bit, I also believe that I need to tune the hammer spring and reg as the rifle was originally setup as a .22 shooting 18.13 at 900 fps. I am going to break it down and start from scratch this afternoon and dial it in to around 910-920

275776716_10221544184703054_201880178986690608_n.1647262332.jpg
275560130_336540178437186_3350642744650970272_n.1647262321.jpg
275506184_336536021770935_2167825517094312416_n.1647262321.jpg

 
@Kevo1288 It didn’t register until I came back and read this post a second time. 25 MPH WINDS!! Damn it! That’s a good looking group! Well done!! What was your POA?

I was WAY over compensating and my POA was the very top left corner of that target, where paper met wood, I fought these winds all day and it was truly frustrating as they were not constant but consistent enough to really mess with any 5 shot groups I shot. The flag more or less didn't ever fully drop all day. 

At the end of the day I had a blast and would like to revisit these conditions after tuning my rifle to about 910-920 fps with the same round. For shooting such a light projectile I am in no way displeased with any of the groups yesterday, this just happened to be the best. The others were twice this size.

Also middle picture was zeroing at 50, my shooting partner had to zero in his M77 .270 as I had given him an old scope I had and we needed to get that on paper.
 
@Kevo1288 That’s some serious wind reading and windage holding. Nicely done.

Thank you! 



Very good group in wind and that far out there. Obviously you’re going to be getting super groups on calm days. Thanks for sharing. Looking forward to seeing more!

My profile avatar is 2 separate 5 shot groups at 80 yards on a completely calm day off a tripod. Thanks for the positive reinforcement!


I don't know if yours has a power plenum or a Huma pin probe, but those are 2 easy ways to create more power without upping the reg.


It has a power plenum on it I do know that!