42 grain Varmint Knockers

[Zeringue]

So I was finally able to shoot a group out to 100 yards with my 700mm Uragan 2 25 cal using Varmint Knockers Knurled .253 and man what a combo this makes. I ran down the slug rabbit hole with my Maverick and never could get it, thankfully Derrick Wall made sure that didnt happen this time. 50 yards is a cake walk and repeatable (Pic 1 and 2) Now for 100 yards, there was a good 10-15 mph wind that day. And you can definitely tell. I was aiming at the orange diamond first 3 Shots all touching, 2nd 2 shots wind died down both touching. These aren’t hand picked these are the only groups I shot at 100, I went to steel right after. The bigger group in the middle was my godchild‘s first attempt ever at a 100 yard Group. I would definitely check out VK knurled slugs if you havent. I have another 1000 on the way, average FPS was 932.

 

[JaceSpace1369]

So I was finally able to shoot a group out to 100 yards with my 700mm Uragan 2 25 cal using Varmint Knockers Knurled .253 and man what a combo this makes. I ran down the slug rabbit hole with my Maverick and never could get it, thankfully Derrick Wall made sure that didnt happen this time. 50 yards is a cake walk and repeatable (Pic 1 and 2) Now for 100 yards, there was a good 10-15 mph wind that day. And you can definitely tell. I was aiming at the orange diamond first 3 Shots all touching, 2nd 2 shots wind died down both touching. These aren’t hand picked these are the only groups I shot at 100, I went to steel right after. Average FPS was 932.

View attachment 524416

View attachment 524417

View attachment 524418

View attachment 524423

Awesome shooting! Do you have the AOA kit in your rifle as well or did he just tune it up for ya?

 

[Zeringue]

Awesome shooting! Do you have the AOA kit in your rifle as well or did he just tune it up for ya?

No AOA kit. Reg is set to 170 bar 35 shots from 270 bar to 170 bar. I wanted a slug tune and wasn’t worries about shot count.

 

[JaceSpace1369]

No AOA kit. Reg is set to 170 bar 35 shots from 270 bar to 170 bar. I wanted a slug tune and wasn’t worries about shot count.

Gotcha! Damn, that's not bad though for the power you're putting out.

 

[Ezana4CE]

So I was finally able to shoot a group out to 100 yards with my 700mm Uragan 2 25 cal using Varmint Knockers Knurled .253 and man what a combo this makes. I ran down the slug rabbit hole with my Maverick and never could get it, thankfully Derrick Wall made sure that didnt happen this time. 50 yards is a cake walk and repeatable (Pic 1 and 2) Now for 100 yards, there was a good 10-15 mph wind that day. And you can definitely tell. I was aiming at the orange diamond first 3 Shots all touching, 2nd 2 shots wind died down both touching. These aren’t hand picked these are the only groups I shot at 100, I went to steel right after. The bigger group in the middle was my godchild‘s first attempt ever at a 100 yard Group. I would definitely check out VK knurled slugs if you havent. I have another 1000 on the way, average FPS was 932.

View attachment 524416

View attachment 524417

View attachment 524418

View attachment 524423

@Zeringue Either my vision is going or the pictured slugs aren’t knurled. Did you purchase them knurled, did you knurled them, or did you have someone knurl your slugs?

 

[Zeringue]

@Zeringue Either my vision is going or the pictured slugs aren’t knurled. Did you purchase them knurled, did you knurled them, or did you have someone knurl your slugs?

They are lightly knurled. Let me get a good pic

 

[Zeringue]

@Zeringue Either my vision is going or the pictured slugs aren’t knurled. Did you purchase them knurled, did you knurled them, or did you have someone knurl your slugs?

Left is VK knurled right is h&h

 

[JaceSpace1369]

@Zeringue Either my vision is going or the pictured slugs aren’t knurled. Did you purchase them knurled, did you knurled them, or did you have someone knurl your slugs?

They are knurled lightly, you can barely tell due to the packaging being a thick plastic and somewhat opaque.

 

[Zeringue]

I didnt wash them, but I did place them in microfiber towel and ran them back and forth to remove any large flakes and in separate towel lube them with ballistol.

 

[Ezana4CE]

Left is VK knurled right is h&h

View attachment 524439

Now I can see it. Are these a new offering?

 

[Zeringue]

Now I can see it. Are these a new offering?

When Derrick tuned my gun he he mentioned knurled slugs. I looked on Dales eBay page didn’t see them. So I messaged him he said to buy any 25 cal ammo and in the not put 42 grain knurled. Its a lil extra but to me is accurate to worth it.

 

[Ezana4CE]

@Zeringue That sounds like some pretty awesome support.

 

[Zeringue]

Forgot I never posted my gun here is my Uragan 2 25 cal 700 mm. I did try an Eagle Vision Muzzle Break Tuner but ended up taking it off because my groups were better without it. Though I will not write it off just yet As I didn’t give it proper attention that it deserved.

 

[sonnysan]

So I was finally able to shoot a group out to 100 yards with my 700mm Uragan 2 25 cal using Varmint Knockers Knurled .253 and man what a combo this makes. I ran down the slug rabbit hole with my Maverick and never could get it, thankfully Derrick Wall made sure that didnt happen this time. 50 yards is a cake walk and repeatable (Pic 1 and 2) Now for 100 yards, there was a good 10-15 mph wind that day. And you can definitely tell. I was aiming at the orange diamond first 3 Shots all touching, 2nd 2 shots wind died down both touching. These aren’t hand picked these are the only groups I shot at 100, I went to steel right after. The bigger group in the middle was my godchild‘s first attempt ever at a 100 yard Group. I would definitely check out VK knurled slugs if you havent. I have another 1000 on the way, average FPS was 932.

View attachment 524416

View attachment 524417

View attachment 524418

View attachment 524423

Have you tried the MP 47 & 50gr. variety?:

Bot Verification

6,42 mm air pellet – 8 cavity mold - Version 3 - MP-molds

Best moulds for casting lead bullets. Hollow point, hollow base or solid bullets. Molds are Brass or aluminum.

www.mp-molds.com

 

[Airgun-hobbyist]

Great looking groups! Given the proper length to fit, this Varmint Knockers knurled slug might work well in the Huben GK1.