5/8" inlet valve to fit paintball tank?

Jump to latest Follow Reply
If you watch ebay you can sometimes find scba valves that guys have "re-threaded" to fit the tanks, but I would worry about the "quality" of the job being an issue without knowing who did it.


What I did was use the ninja regulator. You can basically us a spacer and bypass the regulator function if you want. I set mine to 3000psi.

Most guys don't like these due to the "troubles" with the fill systems. Hard to turn on/off. I picked up one of the below ASA'a and it is just as it says:

"This ASA use's what we call 'System Bleed' and 'Virtual Resistance' Due to the fact that it has virtually no resistance at all while turning it on or off. System Bleed will bleed all the air from your tank lines allowing you to easily remove your tank after degas. "

Even with 3K on the knob it screws open (down) effortlessly. Then when the gun is full you just un-screw it. The valve turns off, then you continue un-screwing and it bleeds the line. I just put a 2" gauge on one port and a micro line on the other.

https://www.amazon.com/Custom-Products-2k5-Off-ASA/dp/B00BIDXWDU

I got mine last year off ebay for $24.95. Watch there and you should be able to pick one up for under $30
 
Upvote 0
You must log in or register to reply here.
Top Bottom
Back
Home
Forums
Resources
Menu