Does anyone here hand cast their own big bore slugs ? I’m casting several slugs for .257,.308, .218, .251 .. I am in the market for .510 slug molds . Curious to see what you guys are using .
Airforce .510 Texan hand cast choices
- Thread starter AirgunAndy89
- Start date
I've had reports that this is a good one to test:
noebulletmolds.com
No one has ordered any of the Lee casts to date.
View attachment Sonnyslugs_2.1.6.xlsx
510-401-TC-BJ6 4 Cavity PB | NOE Bullet Moulds
noebulletmolds.com No one has ordered any of the Lee casts to date.
View attachment Sonnyslugs_2.1.6.xlsx
Upvote 0
I have hand casted several diff. .510 slugs with limited success. Best results thus far has been with the Rebaited Boat-Tails from African Air. I'm still relatively new to hand casting and have much to learn.
Last edited:
Upvote 0
The biggest thing for me is weighing each one into the prevailing weight class .. and it’s painstaking for those little .218 40 grain slugs I’m use to . So I’d like to branch out to some .50 cal stuff mostly hollow points to hunt with .. and they are less finicky about weight .. I have all the dies for sizing them from .495-.513 just no molds unfortunetly
Upvote 0
A Lee .515 2 cavity mold 450 grain will get you started..My best mold is a NOE 450 Grain Gas Check design...I also have Accurate molds that shoot good..Can give you slugs before you buy a mold to see if they shoot..
Upvote 0
I dont have the mold any more but it was a noe .512 or .513 it ended up casting huge hollow points at 474 grains..They shot good in my Texan. I still have 25lbs or so.. I dont use the hollow points for hunting anymore.
Upvote 0
My favorite mold for my Texan...These are my free wheel weight lead slugs..It's my go to...Shoots one hole at50 yards if you do your part...
Upvote 0