Advice for everyone who had a problem with tearing the o ring on the hatsani when filling. simply put a small amount of silicone grease on the oring. none of them broke anymore ..
Tuning Advice for everyone who had a hatsan pcp
- Thread starter Hatbull
- Start date
thats good advice for all your orings ..i prefer an oil over grease, and since i mess with rc cars always have bottles of silicone shock oil around ..
Upvote 0
It would be nice if all the manufacturers did away with fill probes and made the foster quick connection standard
Upvote 0
Along with the grease or oil you should keep your probes protected from debris by using these-
Got these on all my probes, from Bagnall and Kirkwood
Got these on all my probes, from Bagnall and Kirkwood
Upvote 0
i use different ID rubber hose to store my probes in.
and use small rubber end caps for the male foster
always works good !
just a few of many i have.....
and use small rubber end caps for the male foster
always works good !
just a few of many i have.....
Upvote 0
Hatsans are bad for the sharp edge they leave in the fill port hole!!!!!!!!!!! Where the opening goes from the 45 degree to straight in,, is the sharp edge, it needs to be rounded/sanded
O-RINGS DO NOT LIKE SHARP EDGES, it cuts the o-rings, (rocket science stuff)
O-RINGS DO NOT LIKE SHARP EDGES, it cuts the o-rings, (rocket science stuff)
Upvote 0
I kept tearing the soft white oring that come with the gun.
however…I have now been using the same set of regular bunaN 70 for years.
I think the white ones are just to soft.
also agre..if there is dmg or sharp edges. That has to be addressed.
foster rules!!
however…I have now been using the same set of regular bunaN 70 for years.
I think the white ones are just to soft.
also agre..if there is dmg or sharp edges. That has to be addressed.
foster rules!!
Upvote 0