Other AirForce Knockoff First Look + Other Pinty Guns

Jump to latest Follow Reply
Back_Roads said:
I clamped the sear in a vice and could use both hands to steady, take light layers off adjust as needed.
Click to expand...
I'm considering pulling mine out and do a light dusting and lubing on it. It's a good predictable trigger right now but it could stand to be a little lighter on the pull weight. I don't have a pull gauge so I don't know the actual pull weight.
 
Upvote 0
I received the Pinty Carbine yesterday, a nice smaller light weight rifle, size compare to a Daisy 880 or Crosman 760, it would be great for smaller framed people. Trigger is light and predictable, I will believe the trigger gauge readings I have seen LOL
It is not too loud considering power and tiny shroud, but not any louder than a Sheridan BS at 8 pumps. Shot cycle sounds efficient. Crony numbers were right between 880 and 890 fps. 885 being where the duplicate readings were.
 
Last edited:
  • Like
Reactions: DwarvenRanger, sekiar and thammer
Upvote 0
Anyone came up with a good sling attachment for the P-Force? I think the front is easy with a M-Lok attachment point, just not sure about the rear. I have a Magpul MS-4 sling that is just laying around, so looking for a way to have a QD cup either in the rear or more central.

May look for a pic rail side cup to mount on the top rail...

Like this https://magpul.com/rsa-qd-rail-sling-attachment.html?mp_global_color=118
 
Last edited:
Upvote 0
This model needs no tweaking It would of scored perfect if I wasn't behind the trigger LOL


Below Iarget I shot with the P-Force AKA Space Gun"

PForce 10m target.jpeg
 
Last edited:
Upvote 0
Gault said:
So, I went in and modified my sear. It is nice, little creep and a nice 3-4 pound weight. Much improved.

My problem is now the rifle will fire on safe. I made sure the plunger and spring are installed correctly and everything else is functioning.

Thoughts?
Click to expand...
If you colored outside these lines you may have taken too much off the top. My other thought is you missed the hole in the sear with the pin ?
1741546200733.png
 
  • Like
Reactions: Gault
Upvote 0
P-Force.. 3400 psi, regulator at 150bar or (15 mpa) ..

JTS Dead Center 16.08gr. around 920 fps.. Power wheel set to one.. (Center the screw on the last tick mark closest to the breech..)
Olympia slugs, Don't know if it to large or to long 25 gr. 755fps, One +12 (Center the screw on the last tick mark closest to the breech +12 on the dial) (Need to slug the barrel)
AVS .2193 22gr. dish base.. 830 fps, 1.0 on power wheel... (Last tick mark, closest to the breech, center the screw..) I also have a super-well that I am trying...
 
Upvote 0
WOW !!!
The THammer trigger sear is beyond night and day.
If a trigger distracts my attention from the POA the results show in poor groups. This is now the kind of trigger I don't even have to think about. Nice light short SNAP.
I would venture to promise this trigger mod will tighten your groups.

Great job Troy... thank you.
 
Last edited:
  • Like
Reactions: DwarvenRanger and thammer
Upvote 0
You must log in or register to reply here.
Top Bottom
Back
Home
Forums
Resources
Menu