Would like to have quick fill and airtube sizes. Fx needs to get on the ball and put a drawing up. Thanks, chris
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Anyone know bobcat quickfill oring sizes? I have a newer one made this year.
- Thread starter coldfield
- Start date
Fill probe:
70 PUR (Polyurethane)
5.28mm ID
1.78mm Width
Inside the end cap (the end that screws into the breech block):
70 NBR (Buna-N)
30mm ID
2mm Width
70 PUR (Polyurethane)
5.28mm ID
1.78mm Width
Inside the end cap (the end that screws into the breech block):
70 NBR (Buna-N)
30mm ID
2mm Width
Upvote 0
Sorry I gave you the wrong size in my last post, the end cap into breech block side should have this size:
70 NBR
28mm ID
3mm Width
The size I gave you is for the twist cap, which you twist to protect the fill port from contaminants.
70 NBR
28mm ID
3mm Width
The size I gave you is for the twist cap, which you twist to protect the fill port from contaminants.
Upvote 0