Artemis PP 750 It's Here

Jump to latest Follow Reply
C

Chief

Member
Oct 30, 2018
70
1
Oklahoma, United States
Big brown truck just showed up.....Just unboxed it....I'm Impressed

I haven't even filled it yet.....It's a .177.....will try to spend some time on it tonight

1583944696_4921946475e6913f865b0b9.94718600.JPG


1583944722_17535505365e69141293c0b2.81518581.JPG

 
I have put a few hundred pellets through my PP750. Barrel crown was a bit rough and scoring on the last 3mm of lands, with a light choke. Turned off the scoring and re-crowned, polished with some borebright and its now making sub 3/8" five shot groups at 25 yards with many pellets JSB 8.4 , JSB RS, JSB Heavy, HN Sniper Magnum, HN FTT, HN Terminator... so not pellet picky at all now.

1583959032_18895286435e694bf8910cc5.92997140.jpeg

 
Upvote 0
Ordered mine from Krale. First impressions are that for a $225 pistol this would seriously challenge the Prod. Right out of the box I'd put the Artemis at about the same quality of fit and finish. Haven't had a shot at targets yet but just chrono'd 5 shots between 760-780 in .177 using 7.87gr JSB Express. I'll probably sight it in with 8.44gr tomorrow and see if I won the lottery on barrels - a quick look down the barrel with a flashlight didn't show a polished bore but it seemed smooth the whole way through.

Only 1 thing bothering me immediately is the length of pull when the stock is extended. But it looks like that can be adjusted by trimming the stocks guide rods down an inch or 2.
 
Upvote 0
Chief,

Right on! My 750 showed up yesterday also! 
Unfortunately, I was at work - And didn't remember to bring any pellets in with me. 🤣 

These guns look great! Other than the non-formed-grip, I like it way better than my PP700.
Too much going on, so, I didn't get to fire mine yet, but, when I do, I'll get some chrono #s 
as well as initial shot measurements. 22 caliber version and at 10m distance. [indoor range]

Can't wait!

😊👍

Sam -
 
Upvote 0
A few simple mods - 

It bothers me that the stock doesn't lock into position when closed and I wanted to reduce the LOP by about 2 - 2.5". I few minutes with a Dremel:

1584054668_452426155e6ac18cd86aa8.90881535.jpeg


1584054679_10895570715e6ac197dc5278.98948540.jpeg


I also had a bunch of .177 mags from my Diana Chaser that I was thinking "Hey, these will work with Artemis too!". Yeah, that's a big nope there. Same freakin magazine but different cuts on the back. Again, enter the Dremel. If you do this just remember to keep a small nub to stop the mag from going in further - the magnet hold it's in place plenty fine.

1584054753_19521466795e6ac1e13911f4.07922254.jpeg

 
Upvote 0
You must log in or register to reply here.
Top Bottom
Back
Home
Forums
Resources
Menu