Of course, I can’t find the fill probe for me Ataman ap16. None to be found online anywhere! Anybody have an extra one?
I have a hand full of actual Ataman probes and two aftermarket probes. I did some measuring yesterday.If you dont find the piece, please send me the dimensions and I can make one for you.
Sounds like problem solved, to me.I have a hand full of actual Ataman probes and two aftermarket probes. I did some measuring yesterday.
Despite what nicktrak (the op) thinks, ALL (from BOTH pistols AND a BP17) of the Ataman probes are the same out to .000" points. The aftermarket ones are also the same as each other, but slightly (about .0175") larger than the Ataman probes.
But, nicktrak doesn't believe me...so, there is that !
I can get my mics that go out to .00000" points and measure my Ataman probes. But I'd bet that nicktrak won't believe that either.
Mike
Sounds great!!I have a hand full of actual Ataman probes and two aftermarket probes. I did some measuring yesterday.
Despite what nicktrak (the op) thinks, ALL (from BOTH pistols AND a BP17) of the Ataman probes are the same out to .000" points. The aftermarket ones are also the same as each other, but slightly (about .0175") larger than the Ataman probes.
But, nicktrak doesn't believe me...so, there is that !
I can get my mics that go out to .00000" points and measure my Ataman probes. But I'd bet that nicktrak won't believe that either.
Mike
Jesus! A bit sensitive aren’t we . I simple thought there were 2 different probes!I have a hand full of actual Ataman probes and two aftermarket probes. I did some measuring yesterday.
Despite what nicktrak (the op) thinks, ALL (from BOTH pistols AND a BP17) of the Ataman probes are the same out to .000" points. The aftermarket ones are also the same as each other, but slightly (about .0175") larger than the Ataman probes.
But, nicktrak doesn't believe me...so, there is that !
I can get my mics that go out to .00000" points and measure my Ataman probes. But I'd bet that nicktrak won't believe that either.
Mike
Sure!! please only send me the dimensions. I need them to start the project.Ok… I have an original on its way… I might have you make a couple more
please make me one let me know how much and thanksI only need the dimensions as showing in the drawing. I can do using stainless steel.
View attachment 407566
If you have the dimensions I can do one using stainless steel.please make me one let me know how much and thanks
I was hoping you had already made some but I will try and get the dimenaionsIf you have the dimensions I can do one using stainless steel.