I'm trying to find a replacement shroud or advice on straighting mine out. I've managed to get a significant enough dent in mine to cause my POI to be cursed. I can jam folded up paper between my shroud and tank to bring back a fairly consitant group but am looking for a fix and not a band-aid. Thanks
AVA barrel shroud help!
- Thread starter Lrios
- Start date
Kinda goofy but you could try to get some 1/2 or 3/4 PVC pipe or dowel rod (not sure what size-would want biggest that would fit so you are a bit smaller than ID of shroud but not too small) and cut it extra long to put in there and roll it on a flat table and use the pipe like a rolling pin's handles to bend it back straight
Upvote 0
2pcs 600MM Length Carbon Fiber Tube 25x23x600MM,10/12/16/22/30/35MM Available,3K Roll Wrapped Twill Matte Finish https://a.co/d/e9VJPH1
this is the one I’m using. I can cut to length to your likings and tap for factory thread on both end.
this is the one I’m using. I can cut to length to your likings and tap for factory thread on both end.
Upvote 0