Air Venturi Avenge-X Tactical Hammer Spring Tool

[Evolve 3D]

We’ve identified some issues with our current Avenge-X hammer spring tool, specifically with the belt and pulley system—over time, the belt can stretch and slip. I’ve redesigned the tool to use gears instead, which should provide significantly more torque.

 

[jaysskybound]

We’ve identified some issues with our current Avenge-X hammer spring tool, specifically with the belt and pulley system—over time, the belt can stretch and slip. I’ve redesigned the tool to use gears instead, which should provide significantly more torque. Parts are arriving at the end of the week, and I’ll begin testing soon. Once testing is complete, I’ll send out samples for feedback and work on making these available ASAP. If you’re experiencing issues with the original version, please reach out—I’d love to help you upgrade to the new design!

View attachment 527002

This looks way easier than the ground down allen wrench I made. Sign me up!

 

[MattR302]

Following. Just bought a Tactical and was wondering how to get in there

 

[jaysskybound]

Following. Just bought a Tactical and was wondering how to get in there

I found that if you're looking to reset hammer spring to zero, removing the stock and turning it all the way down is best.
Then as you increase H.S. little by little, I ground down an allen wrench so it fits, and can turn it ¼ turn at a time.

 

[MattR302]

I found that if you're looking to reset hammer spring to zero, removing the stock and turning it all the way down is best.
Then as you increase H.S. little by little, I ground down an allen wrench so it fits, and can turn it ¼ turn at a time.

Thanks. Once I figure out how to remove the stock, I might try to drill an access hole to use a long Allen key to get in there

 

[jaysskybound]

Thanks. Once I figure out how to remove the stock, I might try to drill an access hole to use a long Allen key to get in there