This sure makes it easier to cock it. Painted flat black. 
Benjamin Thumb Rest Mod
- Thread starter SniPeralez
- Start date
The thumb rests make the M-Rod easier to cock than a side lever. And I have two rifles equipped with side levers and two with bolts and the thumb rest.
Upvote 0
AGR has a machined thumb rest in black oxide that takes blue nicely. Maybe a little more finished looking than a hex head bolt for the OCD types out there.
www.airgunrevisions.com
Marauder Thumb Rest - Airgun Revisions
Add a bit of comfort when cycling your charging handle with this AR exclusive Thumb Rest. Just screw into back of air tube. Rest your thumb on it while grabbing charging handle and squeeze your hand. Aids in smoother cocking as well bringing your index finger lower on bolt handle…
www.airgunrevisions.com Upvote 0
LolAGR has a machined thumb rest in black oxide that takes blue nicely. Maybe a little more finished looking than a hex head bolt for the OCD types out there.
Marauder Thumb Rest - Airgun Revisions
Add a bit of comfort when cycling your charging handle with this AR exclusive Thumb Rest. Just screw into back of air tube. Rest your thumb on it while grabbing charging handle and squeeze your hand. Aids in smoother cocking as well bringing your index finger lower on bolt handle…
Upvote 0
A belt sander will work too, if so inclined to round it out. I just took the sharp edges off.AGR has a machined thumb rest in black oxide that takes blue nicely. Maybe a little more finished looking than a hex head bolt for the OCD types out there.
Marauder Thumb Rest - Airgun Revisions
Add a bit of comfort when cycling your charging handle with this AR exclusive Thumb Rest. Just screw into back of air tube. Rest your thumb on it while grabbing charging handle and squeeze your hand. Aids in smoother cocking as well bringing your index finger lower on bolt handle…
Upvote 0
I was not being critical, in fact, I have the bolt you suggested on my shopping list, thank you. I will not use my bench top belt sander to do anything other than smooth off the top surface. I think I will hit buy now
. I want black oxide, that way I can blue them.
My .25 M-Rod Gen 1, AGR thumb rest, AGR, hybrid reservoir tube, AGR SSG, modded custom valve, bottle brush depinger, Maple Customs single loader.
On a side note, I tried the Boyds stocks like those, have several Boyds on PBs. But the M-Rod just sits so high there was no cheek weld at all, more like a chin weld or no weld, how do you get along with them?
Last edited:
Upvote 0