bipod on a notos?......YES :)

[starlingassn]

well,
took a bit on the belt sander,
and needed a thin bit of foam rubber between the mount and tube as the mount
(air venturi quiver and bipod mount from pyramyd)
is 1mm larger in diameter than the tube on the notos.

but it works bipod on a notos.

i have another bipod mount for the pp750 coming in the mail that will fit the tube better,
but dont know if it will work without removing the large top rail on the notos,
as the rail/shroud section sits tight against the air tube.

 

[starlingassn]

a few more pics to show that it does not touch the shroud/rail.

 

[starlingassn]

update!

the pp750 bipod mount from wes came yesterday,

its a WAAAAAAYYYYYY better choice than the mount from pyramyd!

it only took cutting out a portion of the center section so it didnt touch the rail/shroud,
and added double sided t-rex tape to the inside of the mount since cutting it in half reduces the clamping strength,

its much more solid than the pyramyd mount,
plus its smaller,lighter,and more streamlined.

 

[starlingassn]

plus the pp750 bipod sits closer to the airtube than the pyramyd mount

 

[L.Leon]

plus the pp750 bipod sits closer to the airtube than the pyramyd mount

View attachment 335745

You have it set up nicely, I like it a lot. Looks light and handy.

 

[Perle]

Can you provide a link for the tank clamp ?

Need that part.

 

[starlingassn]

sure thing.

like i said,youll have to cut out the middle portion (just enough so it does not touch the shroud/rail)
i took out about 3/4 inch.
double sided tape helps it stay put also.

PP750 bottom Picatinny rail

airgunarcheryfun.ca

 

[Perle]

sure thing.

like i said,youll have to cut out the middle portion (just enough so it does not touch the shroud/rail)
i took out about 3/4 inch.
double sided tape helps it stay put also.

PP750 bottom Picatinny rail

airgunarcheryfun.ca

Thank you sir. No problem I’ll cut that sucker ….

 

[starlingassn]

Thank you sir. No problem I’ll cut that sucker ….

dig it
welcome

 

[Healthservices]

Looks like the krale rail will bolt up to the regulated air block.

Allen

 

[thumbs]

update!

the pp750 bipod mount from wes came yesterday,

its a WAAAAAAYYYYYY better choice than the mount from pyramyd!

it only took cutting out a portion of the center section so it didnt touch the rail/shroud,
and added double sided t-rex tape to the inside of the mount since cutting it in half reduces the clamping strength,

its much more solid than the pyramyd mount,
plus its smaller,lighter,and more streamlined.

View attachment 335742

View attachment 335743

Just ordered the mount from Wes. Thanks for the information, Anyway when I get the mount I am assuming the mod will be obvious? Thanks