Brocock/BRK Brk Ranger xr.

Jump to latest Follow Reply
Blejda said:
Hi
Yes it was very low on power when i got it and eventually it got to only 3 fpe and when i checked the hammer spring it was very loose and almost all the way out.
When i adjusted it was on specs which is 18 fpe.
Regards Marko
Click to expand...
Hopefully it was a QA issue that you resolved…. I wouldn’t be concerned unless it backs out again
 
  • Like
Reactions: Blejda and Ranchibi
Upvote 0
@Blejda, glad you sorted it out, like @cavedweller wrote, simply monitor it to see if it backs out again. Keep us posted, was just doing some nighttime plinking with my Atomic at 25 and 40 yards. The Rangers and Atomics are super sweet PCPs, I love that I can pump them up by hand and body weight. So nice I own two…🙏
IMG_1450.jpeg
IMG_1515.jpeg
 
  • Like
Reactions: Contndr35BB
Upvote 0
L.Leon said:
@Blejda, glad you sorted it out, like @cavedweller wrote, simply monitor it to see if it backs out again. Keep us posted, was just doing some nighttime plinking with my Atomic at 25 and 40 yards. The Rangers and Atomics are super sweet PCPs, I love that I can pump them up by hand and body weight. So nice I own two…🙏
View attachment 507199View attachment 507198
Click to expand...
Hi L.Leon you have nice setups.
Will keep you all posted but i didn't even have time to zero it yet,working 10-12 hr and two small kids.
I was a little hesitant to buy it first because my not so good experience with Bantam sniper but it looks so good and its compactnes and folding stock was deciding factor.
Will see how it shoots and let you all know.
Regards Marko
 
  • Love
Reactions: L.Leon
Upvote 0
SM3751 said:
If the spring adjuster is the same as the Concept XR, then check on the two white nylon set screws on the spring adjuster. My Concept XR had the same problem new, and I’ve not had an issue since tightening them up.
Click to expand...
Same for my and my Atomic. I had to tighten down the two white nylon screws above above the hammer spring to prevent any slight movement.
 
Upvote 0
Seanbuds said:
Here's where the two screws reside. You need to take apart the bottom portion/trigger guard from the receiver to gain access.

View attachment 510312

This part below needs to be removed.

View attachment 510313

I can take apart mine and provide more detailed pictures if needed.
Click to expand...
Mine doesn't have part 52
I adjust hammer spring with 51 and there is nothing behind it with stock open.
Regards Marko
 
Upvote 0
  • Haha
Reactions: Seanbuds
Upvote 0
You must log in or register to reply here.
Top Bottom
Back
Home
Forums
Resources
Menu