I need to replace the hammer spring in my ghost. I assume I pull the three screws out of the back and go from there. Any other tips. Couldn’t find a how to video on line. Thanks!
Brocock/BRK Brocock Ghost Hammer Spring replacement tips?
- Thread starter bdzjlz
- Start date
Check toward the end of franklinks post he has great descriptions and dialogue on the ghost better than i can do. Its easy though so don’t worry
www.airgunnation.com
BRK Ghost Review
Ron's Textreme matches must be a real hoot with you guys ribbing each other back and forth! Always a blast if you can keep Ron from talking so much in the shooter's meeting. Oh, and don't give him a chance to brag on his accolades. Can you say looooooong winded?!?! Holly smokes, humility is not...
www.airgunnation.com Upvote 0
Take off the plastic buttpad first.
The current production version is the one on the right.
Remove the four bolts holding this shoulder piece to the gun. (Three in the triangle pattern up top and one down lower, in the slot for the plastic buttpad).
Shoulder piece drop down and hammer spring tension wheel will detach from the gun. That will allow the hammer spring to be removed and replaced.
Replace the drop down, the four bolts, and then the plastic shoulder piece.
The current production version is the one on the right.
Remove the four bolts holding this shoulder piece to the gun. (Three in the triangle pattern up top and one down lower, in the slot for the plastic buttpad).
Shoulder piece drop down and hammer spring tension wheel will detach from the gun. That will allow the hammer spring to be removed and replaced.
Replace the drop down, the four bolts, and then the plastic shoulder piece.
Upvote 0