Brocock/BRK Brocock help

[ShadyBrady]

Dissasembling brocock bantam...Does anyone know what size/ threading this is? I'd like to remove the air stripper and mount moderator straight to barrel if possible, but its way too small.. Stripper/shroud don't seem to quiet it much at all, and I'd like to buy a thread adapter if possible.

 

[ShadyBrady]

I'll also add that I started getting fliers. Thought maybe stripper was loose. It was not... so still have that problem to solve also lol

 

[L.Leon]

Reach out to Shane at AOA, he and any of the techs can give you your answer.

 

[ShadyBrady]

That's a good idea. Just eyeballing it, it looks a mighty lot like m10x1. I'm hoping going through the gun and tightening everything up solves the issue. It will throw 2 or 3 low right... and I will adjust scope. Then a few shots later it will shoot high left, where originally zeroed. No clue... hoping this isn't a reg issue

 

[ShadyBrady]

Shot them an email

 

[Smitty911]

Have you cleaned the Barrel recently?

Smitty

 

[ShadyBrady]

Yes, then per the instructions fired a felt cleaning pellet. When I did a small white plastic cap flew out behind the felt. I'm thinking this is the tip off the firing valve? Im unsure .I can not catch a break