Burris Signature Rings the only way to go.....

[Tumblinginflight]

Having installed and tested many of these, they work better and hold properly under heavy recoil when the pluses and minuses are matched correctly. I’m sure you can get away with other techniques- I’ve mixed them before to get zero cant as well- but following the design intent works better. Also important to keep in mind that basic trigonometry is at play, and the included instructions have a table showing the ring spacing/cant relationship. While I do like these rings, if you buy enough sets you will encounter ones machined very poorly with natural misalignment. I currently have one set that requires ~12MOA of windage to correct the ring, and another that is pushing ~20! I have tested and verified that the error is in the ring itself. That eats up a lot of the “adjustment”. In my use, I can correct and still get the vertical I need, otherwise I’d warranty them. Still just sloppy QC on Burris’s end.

 

[bustachip]

Thank you all for this post. I am currently working on getting a 70 year old pb ( Martini International )on target . This sure helped. Thanks again.

To make it simple all you want to do is to point the scope at the bullet hole, where ever it landed.
There's many combinations you can do with these eccentric offset inserts. They're not expensive, I bought like two of every one they make.

 

[mh]

Are extra inserts available for 30 mm? All I could find was for 1 inch.

 

[karl_h]

Are extra inserts available for 30 mm? All I could find was for 1 inch.

All of my 30mm signature rings came with a set of inserts, but then I bought them all within a couple months after buying my first set and that was 20+ years ago. If you call burris, you can get them directly from them.

 

[Joedirt199]

Got a set of these inbound with some extra inserts. Got a problem with my Taipan scope rail being off center. I hit left at 12 yards, on at 25, and right at 50. Tried flipping the scope rings to see if the rings favored a side. Nope, still hits left at close range. Hoping to adjust the scope center with the spacers so the shots fall in line with the reticle.

 

[Longbow53]

If anything will do it ,it will be these shims!

 

[JEFFPPC]

The last 2 sets I bought only come with the 0 inserts. The others must be bought as a separate item.

 

[Revoman]

They have two different sets, one a Signature, having a single screw clamp , the other a Signature XTR, having a 3-screw clamp, which I believe still has 0, 5, 10, 20 inserts (?).

mike

 

[bustachip]

The last 2 sets I bought only come with the 0 inserts. The others must be bought as a separate item.

Correct.

 

[Longbow53]

I ended up buying the Gunsmith container that has like 15 of each insert in a nice plastic box. Back when I put on air rifle Matches ...it was the norm for the guys to bring there gun up and we shimmed till we got nearest bullet hole . amazing how far off some of these guns were.....