Or maybe low on fund. So with some free time, I’ve decided to make my own Veteran 2.0. Maybe another one or two more rev then I’ll be happy. So far, I like it!!!
Can’t justified for Veteran 2
- Thread starter Thach2264
- Start date
I would like one for a single mag. I'm not sure why I would need 6 mags on top of a hefty bull pup. All your ammo is exposed to the elements and the extra weight. Don't get me wrong your making some nice stuff and I was looking at some single mag holders. Keep up the good work.
Upvote 0
If you're just playing, maybe try to make the section between the scope towers match the section between the rearward scope tower and the breech block.... continuing the angle/line onto both 3d printed parts. And omit the mag holder function. I kinda like the look that is the result of covering up the bare barrel, and I think it would be further improved by continuing that line onto both parts....
Also, got any ideas in the way of a cheek riser/rest? And not one that just sticks on with double sided tape like I've seen others attempt, but an actual decent method of fixation. Perhaps even a little concave action, ala Tyrolean, but not so much that it becomes a bulky cancerous growth on the side/top of the breech block.
Also, got any ideas in the way of a cheek riser/rest? And not one that just sticks on with double sided tape like I've seen others attempt, but an actual decent method of fixation. Perhaps even a little concave action, ala Tyrolean, but not so much that it becomes a bulky cancerous growth on the side/top of the breech block.
Upvote 0
I’m too focus on making a multi use with mag holder and lost sight of the final look. Yes, straight line same as the breech end cover and low profile would look nice, Edgun like.
Upvote 0