Hello Avenger Fans,
This is a Public Service Announcement for those who want to increase the plenum volume of your Avenger. I just performed this upgrade last night, and it took a WHOLE LOT longer than I anticipated from watching the upgrade being done online. Well, it turns out that there is a tiny set screw that gets torqued down on the actual threads of the Pressure Relief Valve Plug assembly. I just thought that there was lock-tight on the threads, so I gnarled the top couple threads of this plug pretty badly.
Here is a picture of the set screw peeking into the thread assembly. You can also see the 1.5mm allen wrench that I have inserted into it. You have to take the back of the stock off too, when getting to this screw.
Here is a picture of Page 9 of the Avenger Schematics that shows the Pressure Relief Valve Assembly. You can see that part #18 is the set screw, but this isn't listed in the table any where. I consider this to be on me, but I wanted to show this minor discrepancy.
Anyway, I wanted to let you all know about this little "gotcha" to this upgrade. I was able to clean up the mess I made, but I hope that this note will keep someone else from potentially tearing up the threads on this Pressure Relief Assembly. Good luck!
This is a Public Service Announcement for those who want to increase the plenum volume of your Avenger. I just performed this upgrade last night, and it took a WHOLE LOT longer than I anticipated from watching the upgrade being done online. Well, it turns out that there is a tiny set screw that gets torqued down on the actual threads of the Pressure Relief Valve Plug assembly. I just thought that there was lock-tight on the threads, so I gnarled the top couple threads of this plug pretty badly.
Here is a picture of the set screw peeking into the thread assembly. You can also see the 1.5mm allen wrench that I have inserted into it. You have to take the back of the stock off too, when getting to this screw.
Here is a picture of Page 9 of the Avenger Schematics that shows the Pressure Relief Valve Assembly. You can see that part #18 is the set screw, but this isn't listed in the table any where. I consider this to be on me, but I wanted to show this minor discrepancy.
Anyway, I wanted to let you all know about this little "gotcha" to this upgrade. I was able to clean up the mess I made, but I hope that this note will keep someone else from potentially tearing up the threads on this Pressure Relief Assembly. Good luck!
