I just recieved a Beeman 1357 with a FOUR UNCLES hand pump. I can't get any air into the gun. Do i have to setup the gun special? Or is there something i need to do with the pump. The 1357 still has a little pressure in it but i can't move the pressure up at all.... pumped lots of time... It's cold here in Kansas... is that a factor?
N/A charging problems
- Thread starter CEOwen56
- Start date
Make sure you've cocked the gun before you try to pump. That takes the hammer spring pressure off the valve seat. It may also need to be charged a bit higher before your hand pump will start filling. Sometimes if there's not enough or no pressure to seal the valve, a hand pump doesn't have enough pressure/volume at the start to get the gun to start taking air without it leaking out as fast as you pump.
Upvote 0
Best to isolate problem. Pressure test pump with dead-head plug (pictured), inserted in female quick-disconnect at end of fill whip (hose.) (Four Uncles should have included dead-head plug.) Pressurize pump to assure proper operation and no leaks. Release pressure, after test, with bleed valve. If pump OK, problem lies with gun. WM 
Upvote 0
Feel free to come back with additional questions on gun or pump if matter remains unsolved. WM
Upvote 0