Almost have my charging station / workbench completed. Still waiting on a part for the water separator.
/
Charging Station / Workbench
- Thread starter CP598
- Start date
It's too clean and organized. Need to throw some more junk up around the area. 
Seriously, looks like a very nice usable setup. Hope you get a lot of use out of it.
PS-might want to put some split hose over your water lines where they pass near the stainless lines and try to watch separation. Those get hot and can mess up your day.
Seriously, looks like a very nice usable setup. Hope you get a lot of use out of it.PS-might want to put some split hose over your water lines where they pass near the stainless lines and try to watch separation. Those get hot and can mess up your day.
Upvote 0
Sorry, I'm a newbie with questions. Its a Yong compressor that's at the end goes into a Gold air filter, I get that, but what's the box that you are running the tubes into and out of doing? Thanks Mike
Upvote 0
Depends on where/what condtions I guess. Mine stays in unheated shop so antifreeze. Some use other methods.
Upvote 0
Yes, like bandg said. It's the coolant reservoir. I am running straight distilled water. My shop is heated so no need for antifreeze. In the summer, I may freeze some bottled water and throw in there when charging. Right now I'm only filling the gun so it doesn't get very hot. Should have a carbon fiber SCBA tank in a few months, and I may need the ice at that time.
Upvote 0
It's too clean and organized. Need to throw some more junk up around the area.
PS-might want to put some split hose over your water lines where they pass near the stainless lines and try to watch separation. Those get hot and can mess up your day.
Haha.. usually I do have crap everywhere, but I just built the bench so give it time. I was concerned about the water lines and the compressor lines. Right now they aren't touching, but I think I will look into some loom or something to protect them. Thanks for the advice!
Upvote 0
Hope it helps. I've had at least two melted hoses when the compressor vibrates and moves a bit and it makes a mess. Overall a very nice setup.
Upvote 0
Updated my hose routing. They can’t touch the cylinder or the stainless lines now. Thanks for the tip bandg!
I
Upvote 0
Ill be running some antifreeze for the corrosion protection. Great looking stand. Are you running a pump?
Upvote 0
I'm not sure what you are asking about running a pump? If you are referring to a water pump, then yes it's the one that came with it.
Upvote 0
My set up is very similar but it sits on a 3 shelf open-wire stainless steel stand, my tote holds about 7 gals of water, added 1 bottle of water wetter to help pull heat away, I fill a 45 min scba tank, the tank sits on the top shelf, all plumbing runs uphill.
Upvote 0