Hey AGN family. I recently went target practicing with a couple of my airguns. Upon returning home the cocking lever on my AEA .25 challenger pro came completely off. Does anyone know what kind of screw is used to join it back ?
AEA Cocking Lever Screw
- Thread starter Alphabatman601
- Start date
the kind I would be asking manufacture to replace, guns shouldn't fall apart once put together. Now if you've disassembled the gun its a different story.
Upvote 0
No I never take anything off of it. Only thing I have done to it is add optics, zeroed it, shot, and cleaned the barrel.
Upvote 0
Upvote 0
Contact us – The Pellet Shop
At The Pellet Shop, Customer service is our top priority, For any questions or concerns, please reach out to us through the form below or Call/Text us directly at (718) 450-4146 | [email protected] Live Chat HoursMonday - Friday: 10 AM - 8 PM ESTSaturday: 10 AM - 5 PM ESTPhone HoursMon-Fri...
www.thepelletshop.com Reach out to them. They do service on AEA guns and may have extra screws. Not uncommon for a cocking arm screw to fall out. Just a little blue loctite will keep it where it needs to be.
Upvote 0
It's not a screw, it's actually a roll pin.
My calendar Pro did that also. Bin from the pellet shop told me I would have to fix it myself and just go to the hardware store and get a pin. It has not been the most reliable item. It was also not easy to make it perfect because there's very little space.
If I ever buy another aea I would have to see that that is been corrected. I think the elite models may be better but I have not looked at it closely enough and nobody's shown any videos close enough to know.
Because this has been a repeat problem, you're going to need to make a pin that is the correct length and then find out that after you use it it will slide out. I used a Dremel cut off wheel to cut it to the right length and put some grease in the center and then put glue on the end to keep it from sliding out.
Shortly thereafter the main firing valve pin broke. The pellet shop did have a replacement for a decent price.
My calendar Pro did that also. Bin from the pellet shop told me I would have to fix it myself and just go to the hardware store and get a pin. It has not been the most reliable item. It was also not easy to make it perfect because there's very little space.
If I ever buy another aea I would have to see that that is been corrected. I think the elite models may be better but I have not looked at it closely enough and nobody's shown any videos close enough to know.
Because this has been a repeat problem, you're going to need to make a pin that is the correct length and then find out that after you use it it will slide out. I used a Dremel cut off wheel to cut it to the right length and put some grease in the center and then put glue on the end to keep it from sliding out.
Shortly thereafter the main firing valve pin broke. The pellet shop did have a replacement for a decent price.
Upvote 0