That makes sense. How much should I take off the sear? I already ordered it so I’m excited.
Upvote 0
Crossman 1377 pcp coversion project
- Thread starter Twohsieh
- Start date
Hi bud off hand I cant remember
You should get a diagram with it showing you how to do it.
Just remember a bit at a time from the sear.
And make sure after you safety works after ""empty of course.
cock empty gun put safety on" try and pull trigger""
It's not hard to do it correctly just take your time.
If you do get stuck pm me and I'll take a pic of mine for you
You should get a diagram with it showing you how to do it.
Just remember a bit at a time from the sear.
And make sure after you safety works after ""empty of course.
cock empty gun put safety on" try and pull trigger""
It's not hard to do it correctly just take your time.
If you do get stuck pm me and I'll take a pic of mine for you
Upvote 0
Do you need to put a steel breech on it for it to work?Once i fully complete the project i will get some chrony results
12g CO2 Pump to PCP Adjustable HAP KIT for Crosman Pistol 1377 1322 2250 2260... | eBay
Specification: Suit CROSMAN 1377 1322 and longer barrel. We can provide other CO2 or PUMP to PCP solution. To install them, you only need to keep the original barrel, grip & trigger set, and Probe.www.ebay.com
New Crosman STEEL BREECH KIT COMPLETE for .177 air guns 1377 1740 PC77 2300 2400 | eBay
For. 177 caliber models 1377, 1740, 2300, 2400, 1760, PC77 Air Guns (pellet pistols, carbines). New Crosman STEEL BREECH KIT COMPLETE. with this kit plus a. 177 caliber Crosman barrel and barrel band.www.ebay.com
Need trigger grip assembly from donated 1377. Exchange the part in the grip that releases the hammer(included), put on regular 10.25 inch barrel on the 1377. And you are done, pcp chamber comes pre built, regulator is adjustable. I have filled it to 3000 psi. No leakes. Able to go to 4000 but I have reservations to push it that far.
The 18 inch barrel upgrade is optional.
Upvote 0
I dont think so
Screw holes as per original
But im sure forward screw under probe needs to be longer as tube thicker slightly.
I would put multi shot onto it to make the most out of it" but single shot works also.
Screw holes as per original
But im sure forward screw under probe needs to be longer as tube thicker slightly.
I would put multi shot onto it to make the most out of it" but single shot works also.
Upvote 0
Did you ever get chronograph numbers for the pcp 1377? Probably higher with the long barrel vs oem.
Also how is it now, still holding air etc?
Also how is it now, still holding air etc?
Upvote 0
