Dissassembly Guide for FX Royale?

[MP44]

Anyone have pics or know of some where online I can see how to tear the Royale down to change out all the o-rings? 

It has a regulator.

Any help would be appreciated

 

[HavocX]

It is fairly easy and straight forward rifle to work on. Have fun! 

http://www.fxairguns.com/wp-content/uploads/2014/03/Royal-Drawing-and-Partlist.pdf

 

[cj_86]

Thanks for that link guys! I didn't know FX website had these drawings. 

 

[HavocX]

Just a note when reassembling the vale supporter part# D17
I have always noticed that this cannot be bottomed out when putting back back together. I thread all the way down and then back it off a turn or so.

 

[MP44]

Thanks for the info.

 

[MP44]

"HavocX"Just a note when reassembling the vale supporter part# D17
I have always noticed that this cannot be bottomed out when putting back back together. I thread all the way down and then back it off a turn or so.

Any special tools needed?

 

[MP44]

UPDATE

It must have been a loose gauge.

I purchased a complete rebuild kit, including the reg, and gauge from AoA. Since it was a slow leak I was going to wait to re-seal the rifle until my plant shut down at Christmas. Last Saturday I decided to put the new gauge on. I removed the bottle and with no air showing on the gauge I started to unscrew the gauge. Right away I realized the gauge wasn't screwed in tight. Since I already had the new gauge I put it on and tightened it all the way down. The old gauge was bare threads and I used teflon tape on the new gauge.

Since last Saturday it is holding exactly where I filled it to.