Hello, would someone have a metal valve sales link for the edgun r5m? In my rifle I have it set to 130 bars and with less than 1500 shots the original broke
Regards
Regards
Edgun r5m valve
- Thread starter jonhabri
- Start date
Upvote 0
Doesn't the EdGun have some kind of warranty? Have you contacted the dealer where you purchased it from?
That dealer should send you the replacement partfor free under warranty.
That dealer should send you the replacement partfor free under warranty.
Upvote 0
what ammo were you using ? I have a bunch of edguns and only had that problem with 1 ammo
LOU
LOU
Upvote 0
Thank you very much.
Unfortunately I live in Uruguay and the representative here does not have valves in stock and I have to buy them from here to usa.
I am using jsb 6.35 Heavy mk2 870fps Regards
Unfortunately I live in Uruguay and the representative here does not have valves in stock and I have to buy them from here to usa.
I am using jsb 6.35 Heavy mk2 870fps Regards
Upvote 0
After more than half a year waiting for the parts out of stock, I was able to buy them and I received smaller valves than those of the r5m 
Upvote 0
I had one break the same way in my Lelya .22. The reg is set at 125bar and the hammer tension set on the lite side. shoots the hades at 946fps. Was shooting closer to 1000fps before re-adjusting the hammer spring. I did order it with the reg turned up a bit. I kind of wonder if that reg increase caused the failure in it. I think its only a 5 bar difference though. In any case I like where its at now.
Upvote 0
After more than half a year waiting for the parts out of stock, I was able to buy them and I received smaller valves than those of the r5m
It appears you received a Classic Leshiy valve instead of a R5m valve.
I would email the dealer you purchased it from & see if you can get a replacement. Hopefully it won't take over six months this time.
Upvote 0
Hello, well after sending an email to brian and whattsap about the problem and not getting any response from it and I read the messages. The truth is very dissatisfied with Edgunwest for not being responsible for the error I bought an ed thinking that I would not have problems with this rifle and it was a disappointment Someone would have the manufacturer's email to communicate to see if I get an answer. Greetings
Upvote 0
surprised they are not made of metal in first place, there has been quite a few reports of these snapping at that precise point on this forum iirc
Upvote 0