Evanix Evanix leak

[schaps]

I have an Evanix hunting master AR PCP pistol in .25.
after not using it for a while I can no longer get it to fill due to a leak at the filling site ( both hand pump and compressor) I do set in in the cocked position but no difference.Any useful tips without having to send it in for repairs? I’ve heard that spraying the seals with a bunch of silicone oil may help but I don’t have any sitting around

 

[WorriedMan]

Not familiar with gun but few drops heavyweight silicone oil in unattached, inserted fill probe or installed male foster fitting, then let soak, is good starting point. Order some heavyweight silicone oil from Amazon, or eBay, same stuff used for treadmill exercise machine maintenance. WM

 

[Pale_Rider]

Don’t take a shortcut. Replace the seals and have peace of mind that your gun will hold air for a while. Even if the silicone trick works it won’t last long. The evanix ar6 guns are easy to work on with only a few o rings to replace.

 

[Scotay42]

There are only 3 orings in the whole thing just fix it.

 

[schaps]

I don’t have any instructions about how to disassemble. I kinda new at this

 

[schaps]

 

[schaps]

I’m living in Switzerland now. Getting help is difficult. Language barrier. I’d really appreciate any help since I’m desperate. I think that I can get the o rings from hardware store or a supplier. Any chance of a zoom type instruction call please?

 

[Pale_Rider]

Remove the e-clips from the pins on the trigger group. After trigger components are removed it will reveal two screws. After removing the screws you will be able to remove the valve(*the valve is threaded in the tube*). Replace the seal on the valve.

Next, use the fill probe to unscrew the fill port cap to replace that seal.

Hardware store o rings are no good for hpa. Buy this seal kit https://www.ebay.com/itm/274298151751

*when removing e-clips place the gun in a plastic bag. They have a tendency to fly off when removing them