Hi!
Recommendations to increase stock length of pull from 12.5" to atleast 13.5"
Thanks!
Recommendations to increase stock length of pull from 12.5" to atleast 13.5"
Thanks!
Last edited:
FWB FWB 300S Mini- how to increase stock length of pull
- Thread starter ohiochuck
- Start date
well as poorly as the aluminum to wood fits now i would be looking for some 1.5 inch aluminum and just block it out
FWB did make spacers and things ut finding that stuff could be impossible
so if you could get the black off the aluminum then go Delrin
butt pad is looking old so that could be done
you can just make round spacers for test purposes also
pick one and do it
FWB did make spacers and things ut finding that stuff could be impossible
so if you could get the black off the aluminum then go Delrin
butt pad is looking old so that could be done
you can just make round spacers for test purposes also
pick one and do it
Upvote 0
Not a stock builder, but I am a woodworker. Perhaps make a template out of 1/4-3/8 inch stock to match the end of the stock, or better yet, the aluminum mount (as @marflow 777 mentions, it is not flush). Use a template router bit to cut out an endgrain 1" piece. You may want (or need) to leave a 1/16 inch thickness to remove by hand, end grain is a bitch. Then attach it to the end of the stock, screws and glue should suffice, dowels would be another option. If you use the aluminum part as the template, you should contour it back to the native stock with hand tools, such as spokeshaves, and rasps/ files. Sand, then finish to try and match the stock. Re-attach the adjustable part... That's all I got...Cheers! Rick
Upvote 0
Recoil pad spacers. Buy two.
www.midwayusa.com
Kick Eez Stock Spacer 1/2 Black
These spacers are made from a strong lightweight plastic polymer that are easy to fit, grind and finish. The extra long slotted hole at the toe of the...
www.midwayusa.com Upvote 0
those stock spacer look interesting
i am coming to the conclusion that we all need 3D printers, this would be a perfect project for a 3D printer
i am all about wood, easy to work with but as a stock extension i am not sure
one thing in this case it needs to be reversable so the rifles factory form is not damaged
wouldn't a 300s stock work as well if one could be found
i am coming to the conclusion that we all need 3D printers, this would be a perfect project for a 3D printer
i am all about wood, easy to work with but as a stock extension i am not sure
one thing in this case it needs to be reversable so the rifles factory form is not damaged
wouldn't a 300s stock work as well if one could be found
Upvote 0
Upvote 0
FWB themselves made spacers for their standard buttplate, they are typically 10mm thick. Just one of those will get a Junior stock pretty close to a standard one.
Upvote 0
I like the simple tube extensions and longer screws . easy doesn't look bad , you can find pvc tube and die or paint . you could buy / make Dowell and cut /drill .
Upvote 0
