Hello , I would like to know if the FX Impact barrel tensioner kit can be used for a FX maverick ?
Thanks
Thanks
I found the opposite and have some kind of tensioner on all my FX builds.Don’t waste your time as it won’t help. I put one on my impact and could not get it to shoot well. Took it back off. I think is was a fad as you don’t read anything about them.
Thanks , I think I'll give it a try .I found the opposite and have some kind of tensioner on all my FX builds.
To the OP the answer is effectively no. The Impact and Maverick use different length shrouds. For a cheap alternative you can try using a shim between the shroud and the front barrel support. It needs to be just a little bit longer than the gap you have stock. Dont tighten down the shroud like crazy though as you can pull the barrel transferport out of the breech. This will give you the benefit of still having a shroud to help with noise.
You can also buy some CF tubing on ebay or amazon the correct dimensions for your barrel housing and guy to length for an interference fit with a moderator.