FX Crown, so many choices, you pick
- Thread starter Goldwing
- Start date
I got the CF sleeve from 910 airgun tuning and cut it down for the 380mm liner.
I epoxied the sleeve on and made 1 new oring/spacer out of delrin the goes over the sleeve and used a factory spacer at the end.
I epoxied the sleeve on and made 1 new oring/spacer out of delrin the goes over the sleeve and used a factory spacer at the end.
Upvote 0
Upvote 0
Nice work @srtmat! I did something similar, I got a 600mm sleeve and I made two 300mm sleeves for my 177 liners. But I only use 1 spacer at the very end, no issues at all.
Upvote 0
That looks great.
I purchased a 700mm liner and it will cover 2 380mm liners.
I shot this liner with and with out the extra spacer in the middle and I couldn’t notice any difference. Probably not needed. That short little liner is quite ridged now.
I purchased a 700mm liner and it will cover 2 380mm liners.
I shot this liner with and with out the extra spacer in the middle and I couldn’t notice any difference. Probably not needed. That short little liner is quite ridged now.
Upvote 0