FX fx dreamlite question- i put the extra power plenum and new adapter for the 700cc bottle but the entire bottle assembly is shaky

the entire bottle shakes, it has play by the power plenum because i can not screw the plenum all the way till dead end on the thread because the adapter will not align properly..

will it get tight when i refill ?

should i shim the plenum with big washer so it does not wobble?

and there was a big washer inside the original cylinder between the reg and plenum but i did not install it because it kicked my plenum even further from the power block and made the gap even bigger- did i do it right or should i put that big washer back in between the block and new plenum?

DSC_0070.JPG


DSC_0073.JPG


DSC_0069.JPG
 
When you start adding air it will be rock solid.
aha, ok...

so i just need to center the adapter as good as i can- if i don't, then i can always degas and reposition.

but the lite butt stock sucks!

it moves left and right although i tensioned that stupid bolt as far as i could- it has a wheel, maybe i should replace with a 13mm bolt and screw this crap with a wrench down..
 
If the oring seats properly on the ground surface inside by the threads the air pressure will expand the assembly with any thread slop you have.... Within reason.

Dang dude that 700 bottle is a baseball bat on that gun and is a big lever to make it wobble. How did you like it in stock form? If it was 5.5 ft lb then it was probably like a pea shooter.
 
:ROFLMAO:
:ROFLMAO:

i shot a wall with 5.5fpe and the .30cal pellet bounced back and smacked me in the leg like a rubber ball- it sucked

i reached on the only shot that i managed to shoot yesterday (was in holland so i cranked it up) 69j with 714fps/45gr so i will crank up toward 1k and see what comes out..

i like my baseball bat - if i don't shoot you- i will club you with my bat :LOL: