FX FX DRS filling issue

[HashBrown123]

Gentlemen this is democracy manifest!

I have a newly purchased DRS, an FX. When I fill the gun to my desired pressure I shut the valve on the tank and bleed the air line however the bleed will not stop and the gun drops 50 bar.

It's as if the valve in the guns filling port is not shutting.

Can anyone offer any advice on rectifying this situation please as it's become a pain. I'm having to fill the gun to 250 bar to end up with a fill to 200. It's just not correct.

 

[Ries]

Reach out to the store where you purchased it, as it’s still covered under warranty.

 

[R0B]

Normally all.ot takes is to fill a bit more abruptly....are you filling slowly?.

 

[Emu]

Bleeding should be violent, not gradually. That in order that sudden drop of pessure seals the valve.

 

[HashBrown123]

I am bleeding violently, I have a push button dump valve on my bottle for this.

Reach out to the store where you purchased it, as it’s still covered under warranty.

No

 

[Emu]

Does it leak by the filling port or by the lower (alike cartridge magazine) black block that is the plenum?

 

[Emu]

You could try the following:

Remove the stock and insert some silicone grease by the hole of the filling port and then try refilling again.

 

[HashBrown123]

It doesn't leak, it's just the internal valve isn't shutting as I would expect it to when I bleed my air cyclinder upon refilling.

 

[Emu]

It doesn't leak, it's just the internal valve isn't shutting as I would expect it to when I bleed my air cyclinder upon refilling.

Try with the silicone grease.

 

[Emu]

Normally there's a small bolt with an o'ring in the internal,part of the filling port that makes the sealing.

That one could be loose. Tighten it a little many times solve the problem. The point is that I do not know how to get to it on the DRS.

 

[Emu]

This should help:

 

[Emu]

Gentlemen this is democracy manifest!

I have a newly purchased DRS, an FX. When I fill the gun to my desired pressure I shut the valve on the tank and bleed the air line however the bleed will not stop and the gun drops 50 bar.

It's as if the valve in the guns filling port is not shutting.

Can anyone offer any advice on rectifying this situation please as it's become a pain. I'm having to fill the gun to 250 bar to end up with a fill to 200. It's just not correct.

Have you solved the problem?

 

[HashBrown123]

Have you solved the problem?

Apologies for the late reply but yes, I took the valve to bits and sprayed it with brake cleaner. It must have had some dust or something in there, possibly bits of o-ring as the rifle had a burr on the filler hole which was eating o-rings.