yes, but there is a problem with the correct mounting because you need to properly rotate the eccentric and seal. will make versions that will be easier to mount
Upvote 0
Today have done some testing with mp mould 47.2 grain slug in .25 with my friend Impact. FAC power on thise slug was 225ms and after mods ( TP, Pellet probe, 6 gram HW, external plenum )... soeed went to 277-278ms ( around 910fps) at 155bar. More to test on targets.
Also, I got Huma gen 3 reg for my Impact, but something was wrong with it. Culdnt get more power than 110bar...
So, I took washers from FX reg 11 ocs and add 1 more from Huma in total 12.
Reg setings ware from 140 to 200bar ... impresed
Your gun is a second generation Impact correct? Not a MKII
I just wanted to be sure your friend that makes the eccentric plenum has the correct dimensions for the second generation valve housing which is 2mm smaller at the threaded area. Beautiful work on your airgun.
Thanks
Your gun is a second generation Impact correct? Not a MKII
I just wanted to be sure your friend that makes the eccentric plenum has the correct dimensions for the second generation valve housing which is 2mm smaller at the threaded area. Beautiful work on your airgun.
Thanks
Have you contacted the guy who makes the plenum. I think alot of us are interested in buying his plenum. Thanks.
Have you contacted the guy who makes the plenum. I think alot of us are interested in buying his plenum. Thanks.
Your gun is a second generation Impact correct? Not a MKII
I just wanted to be sure your friend that makes the eccentric plenum has the correct dimensions for the second generation valve housing which is 2mm smaller at the threaded area. Beautiful work on your airgun.
Thanks
Have you contacted the guy who makes the plenum. I think alot of us are interested in buying his plenum. Thanks.
We should setup a group buy to bring shipping down. His is powder coated maybe if we can get 10-15 of us interested he said he might shop around for anodizing.
I would like one for Mk2. Hobbyman and I are both Canadian.
Your gun is a second generation Impact correct? Not a MKII
I just wanted to be sure your friend that makes the eccentric plenum has the correct dimensions for the second generation valve housing which is 2mm smaller at the threaded area. Beautiful work on your airgun.
Thanks
Have you contacted the guy who makes the plenum. I think alot of us are interested in buying his plenum. Thanks.
We should setup a group buy to bring shipping down. His is powder coated maybe if we can get 10-15 of us interested he said he might shop around for anodizing.
I would like one for Mk2. Hobbyman and I are both Canadian.
I'm interested and have contacted the supplier via email. Anodizing would be a plus, for sure. Have not sent a confirmation to buy or payment yet. I'm in the USA (CA)...
Those are FX branded Wika gauges so they should be spot on.
Silver Surfer, With Tjs barrel, and a 5 shot group 0.30 cal @ 83 yards, looks like is ok.
I got a fast reply from Michal about the new Plenum Production. He said $100 plus shipping (about $45 to USA) and production starts after 26 August!
They are 3X larger than the original MKII's. Made from 7075 Aluminum, tested to 330 Bar. OD is 33mm and ID is 28mm.
I got a fast reply from Michal about the new Plenum Production. He said $100 plus shipping (about $45 to USA) and production starts after 26 August!
They are 3X larger than the original MKII's. Made from 7075 Aluminum, tested to 330 Bar. OD is 33mm and ID is 28mm.
And those will fit mk2 or the mk1?