OK, so I ordered the O-rings indicated on the schematics and rebuilt the Impact regulator. Took my time and only had a real issue with the O-ring in the block. Now I seem to be having an issue getting the trigger mechanism back in and working. From all the videos and schematics I've looked at, getting the trigger back in should be the easiest step. Anyone have any word of wisdom or special techniques to share? Thanks in advance.
FX FX Impact help needed
- Thread starter rdtricks
- Start date
Lay the thing on its side slide in the trigger assembly after lining up the spring in the hole and remember that the spring is almost straight when pinedup front threw the sear if you didn't adjust anything before removing it should be the same
Upvote 0
And... next time before you take things apart make some pictures in steps how you are removing each piece. If becomes a routine you will see the life is much easier 
Upvote 0