FX FX Impact M4 - 700mm & 800mm question

Jump to latest Follow Reply
A

adzmullen

Member
Apr 12, 2022
26
13
Lancashire, United Kingdom
Hi,

Does anyone know if the new FX Impact M4 700mm or 800mm versions come with a built in barrel tension clamp / block as standard from the factory ?

I read somewhere they did, although I can find no reference to this, but I notice the FX website does not list this as an upgrade / accessory on their website, this would make sense if it has one built in already, but not if it isn't.

Could an owner of one of these models clarify this for me ?

Thanks in advance
 
I can confirm that the M4 does not have a built in barrel tension clamp. Also, the clamp block has been very slightly redesigned together with the new top rail. As a result of this, you cannot use the barrel clamp block from the M3 (maybe with a dremel, but I did not go down this route).

Also noteworthy, the M3 barrel clamp block does have a small circular edge in which the tensioned carbon barrel slots. The M4 regular barrel block
does not have this. So you currently cannot use the tensioned shroud on the M4. Unless there's a add-on replacement part of which I'm unaware. On the other hand: it shoots well enough with the standard untensioned shroud :)
 
Upvote 0
airman_o said:
I can confirm that the M4 does not have a built in barrel tension clamp. Also, the clamp block has been very slightly redesigned together with the new top rail. As a result of this, you cannot use the barrel clamp block from the M3 (maybe with a dremel, but I did not go down this route).

Also noteworthy, the M3 barrel clamp block does have a small circular edge in which the tensioned carbon barrel slots. The M4 regular barrel block
does not have this. So you currently cannot use the tensioned shroud on the M4. Unless there's a add-on replacement part of which I'm unaware. On the other hand: it shoots well enough with the standard untensioned shroud :)
Click to expand...

Super, thanks for the clarification :)

Glad its working well without it too.

Much appreciated sir
 
Upvote 0
Maybe this will make you feel better. I have two m3’s one setup with the carbon barrel tension system and the other with the factory standard shroud. The standard shroud is very accurate and easily matches the tensioned rifle if not better. I wouldnt spend the money on the tension system again after this experience.
 
  • Like
Reactions: adzmullen and Eli_809
Upvote 0
Can any body tell me anything about the 800mm barrel assembly, disassembly. I took mine apart, put it back together after some upgrades and it shot great. However the other day I reached up to take off the stock moderator and try out my new donnyfl, and instead of the moderator turning, the shroud turned, just a little. And I decided I should screw it right before continuing. Well after that, my poi has greatly shifted and my accuracy is not good. Has anyone experienced such a thing?
 
Upvote 0
LDP said:
Maybe this will make you feel better. I have two m3’s one setup with the carbon barrel tension system and the other with the factory standard shroud. The standard shroud is very accurate and easily matches the tensioned rifle if not better. I wouldnt spend the money on the tension system again after this experience.
Click to expand...
What barrel lengths ?
 
Upvote 0
You must log in or register to reply here.
Top Bottom
Back
Home
Forums
Resources
Menu