I just disassembly the impact as following video. I only follow the procedure to 7:25". Tight every components and back assembly .
I even don't know which parts is loose. Any way, it works! Appreciated!
Did you happen to notice the distance the hammerseat extends from the front of the housing with the valve adjuster removed? I'm still trying to determine if that should be 6-6.5mm or 4mm as Ernest mentioned.
Thanks,
Rusty
Don’t increase the ID of the TP but elongate will increase the FPS. Load a pellet normally remove barrel now you have a guide how far you can longate. I would rather convert to a double TP to get more FTS.
I wish we could buy all the high power parts so we don't have to modify the originals.
Don’t increase the ID of the TP but elongate will increase the FPS. Load a pellet normally remove barrel now you have a guide how far you can longate. I would rather convert to a double TP to get more FPS.
Don’t increase the ID of the TP but elongate will increase the FPS. Load a pellet normally remove barrel now you have a guide how far you can longate. I would rather convert to a double TP to get more FPS.
Double TP I can do if I'd get a picture or basic idea ?
Did you check o-rings in transferport and barrel o-ring? Powder could be useful. A little bit of leaking blows powder away. Also if you hear a bang you have to search for leaking.
Also you know in every impact is a shaft that connects hammer to the valve. Half of it works normal pressure but the other half is in regulated pressure. One o-ring is there and if that o-ring dry out or sticky velocity drop.