Tuning FX Impact PP Rear Block - pin missing

[bigHUN]

I got a spare Rear Block and I did all the porting (including the Valve House and peek Valve), when all parts were ready I replaced all at once.

I noticed that I could not pull out the old dowel pin (from the R.Block) which locks the position on the brass (Huma dual port) piece so I just cut a piece of dowel I had in my drawers, knowing the OD won't hold it tight only locates the position. Temporary solution.

For now I have nowhere to shot the Impact so just sits in the case, but I don't want to forget about that pin (my improvised pin) can eventually fall out and get lost if the shooting starts.

I will contact my local dealer from where I got the Rear Block but just in case a question to you folks who did replaced the Rear Block...if you remember was the pin included in the package?

 

[FX-USA]

Hi BigHUN,

You can get pins and smaller replacement parts from FX USA. Just call or e-mail our Customer Service department and they can help you purchase the pin you are looking for. 

Regards, 

FX Airguns USA

 

[bigHUN]

...You can get pins and smaller replacement parts from FX USA. ..

Thanks FX USA, Im sitting in CA/Toronto. I could email AGS to send me a pin, but feels kind of stupid got the block one months ago and raising question only now.

I know that THAT pin cannot fall out unintentionally, I just don't want to forget about it when the game beginns.

I have secured my "first aid" pin in the hole with natural bees wax, good stuff...organic